BaberenaSelf priming slurry pump wholesaleHow to sell
2023-10-06 18:02:36The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level. Different installation requirements: the vertical slurry pump needs to be fixed, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation.Baberena, There is a blockage in the water pump. The above is about how to replace the water seal of Boshan submersible slurry pump. In addition to the water seal, other parts of the pump also need to be replaced in time when they are damaged. Moreover, some parts of the pump are relatively easy to be damaged, the front and rear bearing glands are equipped with oil seals which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing. The packing seal, auxiliary impeller seal and mechanical seal are mainly used. Among them, the packing seal needs small leakage and is not suitable for transporting toxic, corrosive and precious liquids; The sealing of the auxiliary impeller relies on the reverse pressure of the two sealing impellers during rotation to prevent the leakage of the medium, and can also play a role in The motor is scrapped. Moreover, because the length of the long shaft is generally fixed, the installation and use of the pump is troublesome, and the application occasions are subject to many restrictions.
With the arrival of midsummer and the intensification of the contradiction between supply and demand of kerosene, the power supply across the country has been tense again, in the second half of the year, there is still a large gap after Chinas power balance. In the eyes of many people cabinet making is superfluous. It doesnt seem to matter whether there is one, but now it is not. The fire control cabinet is not optional, and it is indeed one of the indispensable members of the fire protection system. Why do you say that? Now, lets have a look. Why fire department The higher the specific speed of submersible slurry pump, the smaller the allowable cutting amount of impeller diameter. In addition to the sealing effect, the auxiliary impeller of the submersible slurry pump can also reduce the axial force.Honest management, If the impeller of the pump is damaged after a long time of use, it will also lead to insufficient liquid supply for the pump. It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating Head refers to the energy obtained from the pump by the unit weight of liquid output by the pump, so head refers to the effective energy obtained from the liquid output by the pump in unit time - that is the effective power of the pump: the equation is PE= ρ GQH (W)= γ QH (W)
Assembly of rotor parts of submersible slurry pump Before assembly, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.average method,BaberenaHH slurry pump, Rotate in the rolling direction until the friction between the impeller and the front guard plate stops, then use the adjusting bolt to move the rotor backward, record the forward and backward movement gap, evenly distribute it between the front and rear guard plates of the impeller until the gap between the impeller, the front guard plate and the rear guard plate is flat, stop, flat belt transmission, V-belt transmission) Do not exceed the rated current.Baberena, The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise,BaberenaScrew deep well pump, so it is easy to burn out the motor. What is the order. If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.