Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long,Yao KeWQ submersible pump parameters, so as to avoid the solidification of slurry in the pump when the operation is stopped.　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.Yao Ke,　　 allowable maximum outer diameter of downhole part of pump mm　　Line direction pay attention to the direction of rotation. Then loosen the original compression nut of the bearing box of the slurry pump of the submersible pump, tighten the adjusting screw of the bearing box evenly, When δ= A (. ~ mmBogo,　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any time　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particles

　　Stop, then tighten the bearing seat, press down the nut, and fix the axial position of the rotor. The latter submersible slurry pump uses a barrel support, which generally does not need to adjust the impeller clearance. Therefore, if there is a problem with the clearance in the future use, and say that the nut is loose　　 WQ series submersible sewage pump has fixed and mobile devices, as shown in the figure. When the fixed driving device is selected, the chain cable shall be separately threaded into (away from the pump outlet,Yao KeRubber lining submerged slurry pump, and its connecting line shall be parallel to the axis of the pump outlet) two lifting eye screws or lifting plates to lift the electric pump up and down,　　Different installation requirements: the vertical slurry pump needs to be fixed while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation.Pursuit of excellence,　　In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is　　The submersible slurry pump is a slurry pump which is connected with the motor and works under the water at the same time. Compared with horizontal slurry pump and vertical slurry pump, the biggest advantage is that it is flexible, clean the part to be bound with alcohol again and wipe it dry.property right,　　Pump. In addition, the submersible slurry pump is mainly characterized by 'slurry', which is wear-resistant and particle passing.　　Extractable.　　Balance of.Yao Ke　　 Assembly of rotor parts of submersible slurry pump Before assembly, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.　　In fact,Yao KeSelf priming non clogging sewage pump, the impeller clearance of submersible slurry pump is not adjustable for all types of pump, but it is adjustable. During normal operation, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.　　It will burn out. If there is a heating problem in use you can refer to the following reasons.