g

The standard laminate floor surface should contain aluminum oxide wear-resistant paper. It has g, and even lower. It is directly sprayed with aluminum oxide on the decorative paper. The state stipulates that the surface wear-resistant revolution of the laminate floor for indoor use should be more than revolutions. Only the floor with g wear-resistant paper can meet the requirements. The wear-resistant revolution of g wear-resistant paperThe number of revolutions can reach -, or even lower than g. It is good if the number of revolutions directly sprayed with aluminum oxide can reach -. For those with low wear-resistant revolutions the material cost is relatively low; because of its low wear-resistant degree, the tool cost during processing is also low. On the contrary, the cost is much higher if the number of wear-resistant revolutions is high.Waterproof: apply waterproof resin or other waterproof materials at the tongue and groove of the laminate floor, so that the moisture and moisture outside the floor are not easy to invade and the formaldehyde inside is not easy to release, so that the environmental protection and service life of the floor are significantly improved;Especially when laying in a large area, it is inconvenient to leave expansion joints and compression strips, it can prevent floor arching and reduce floor contraction joints.PuntaCana,Maintenance methods of reinforced composite wood floor.Then look at the qualityZuenoula,Don&#;t pour the floor wax directly on the wooden floor.Otherwise, there will be traces and traces.Carefully apply according to the wood grain direction of the wood floor. Do not apply or the thickness is uneven.Too little application will cause uneven thickness, and too much application will lead to poor film formation.Keeping thin and uniform is the key to waxing.Do not dilute the floor wax with water.Solid wax must be ground after polishing.Use place of SPC floor: because of its thin thickness, many colors, complete styles and low-carbon environmental protection performance, it can be widely used in kindergartens, offices, office buildings, shopping malls, homes, KTV and other public places. Ecological and environmental protection.Look at the substrate, and look at the substrate inside. There are no impurities in the good substrate,PuntaCanaCan the floor leather stick to the wall, and the color is relatively pure. You can see a lot of impurities in the poor substrate with the naked eye.Most domestic floors use fast-growing forests and wood has been used since - years. However, imported floors especially FSC certified plates, have strict restrictions on wood types, so wood substrates are better. Advantages.

Generally, the plate has a certain degree of expansion, it can be paved with wooden keel for leveling, and then nailed with lath on it. After planing, paint and wax can make the room elegant, extraordinary, clean and warm.A short wooden floor strip has been launched in the market, which can be combined freely according to the size of the room, and can be assembled into a variety of patterns at will.This kind of short plank is more practical,PuntaCanaWood floor specification, but the disadvantage is that the cost is not low.If the floor is made of wood, the wallboard can also be decorated with plates, so that the overall structure of the room tends to be unified.Wall panels can be used as whole wall paneling or only as dado paneling.Wood wallboard is the best for large wallboard concrete wall. It can directly fix the board to the wall with adhesive.If the white ash interior wall of brickwork structure is decorated with wallboard, it shall be fixed for minutes first×mm vertical wood wall reinforcement, and then fix the plate to the wood wall reinforcement with wood screws.Family decorative wallboard is best based on plywood, and its strength is appropriate.Then stick wood veneer on its surface to make up for the deficiency of plywood pattern.After the veneer is pasted, apply one or two layers of matte paint, and the pattern of the wallboard will be clear and beautiful, smooth and three-dimensional.Wood floor and wood wallboard interweave,PuntaCanaComposite wood floor laminate, making the style of the whole room unified, both simple and elegant.On the basis of uniform color or reasonable interweaving, it can make the whole room comfortable and soft, and give people an indescribable sense of mystery.Introduction of floor leatherSolid wood flooringHow to lay lacquer cloth?The construction procedures and methods are as follows: first, measure the structural size of the room accurately;Then cut the lacquer cloth according to the size.Note that the cutting width should be slightly larger than the required width to facilitate overlapping, matching and trimming during paving.The cut floor paint cloth shall be placed at room temperature of no less than ℃ for about hours, so that the crimped part of the floor paint cloth can be fully extended and ready for the final paving.Special adhesive shall be used for paving the floor paint cloth.Before paving, the indoor ground shall be treated first.Inspection standard,Common types: three-layer solid wood composite floor, double-layer solid wood composite floor, new solid wood composite board. waterproof, PVC has no affinity with water, and will not mildew due to high humidity.In southern areas with more rainy seasons, SPC flooring will not be deformed due to moisture, so it is a good choice for flooring.thickness

In order to better prevent excessive water from penetrating into the inner layer of wood floor, when selecting floor cleaner, reduce excessive water as much as possible and dry the mop.In addition, when applying wax after cleaning the wood floor spray wax agent shall be selected to make the wax easy to apply evenly.Wipe off too much oil with a soft cloth to avoid bright spots.Don&#;t rush to choose the wood floor coated with light wax, and dry it naturally at night.Create brilliance, Call a deer a horse: the commercial family pretends that the low-priced tree species are high-priced tree species, which is purely to deceive consumers by using the blind spot of consumers&#; knowledge.Moreover, families with laminate floors should also pay attention to the removal methods of daily indoor formaldehyde.The usual practices are: Open windows for ventilation to let the polluted air spread at any time; Place green plants in the house to let the plants absorb formaldehyde; Use a purifier, such as anion, to filter formaldehyde; Use chemical collectors, such as formaldehyde collectors, to neutralize formaldehyde.Using these methods, you can minimize the formaldehyde content in your room.Let&#;s look at environmental protection first.At the same time, for those who pursue value, The room is small or the light is not very good. Pay attention to the selection of light color flooring. Light color flooring can make the small room look larger.A large room with good light can have thick or thin floors.When asked about the service life and wear resistance of SPC floor in the message area of the message board, it is often mentioned to take out artifact such as fruit knife or key and scratch on the surface of SPC floor. If there are scratches, they are classified as non wear resistance.In fact, the national wear resistance test of PVC latch floor is not simply to scratch on the surface with artifact, but to grind and polish the floor with thick bottom circular stone roller under the condition of kg charging. After how many revolutions of rotation and polishing, the wear-resistant layer on the floor surface is damaged and exposed to the speed of rural grass-roots.The rotational speed of this connection point is an index value considering the wear resistance of PVC latch floor.For example, the minimum speed of national composite floor is rpm.Therefore, the wear resistance of PVC latch floor is professionally measured by the national testing center.stability