Therefore, the stator winding will be burnt out due to excessive temperature rise.　　The above is a brief introduction to the effect and form of shaft seal of submersible slurry pump. Users can choose the appropriate shaft seal type according to their actual needs.North trudou,　　Directly immersed in the liquid most coal washing conditions and power plant conditions are used more. For users who do not know much about the slurry pump, they feel very similar in many places looking at the slurry pump series, or even no difference. In fact, they are basically the same in essence. The difference is in the details, compared with　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time,Curridabat,　　The above is about how to replace the water seal of Boshan submersible slurry pump. In addition to the water seal, other parts of the pump also need to be replaced in time when they are damaged. Moreover, some parts of the pump are relatively easy to be damaged, so we need to replace them regularly during use　　Check whether it needs to be replaced.　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.

　　Do not exceed the rated current.　　In order to make it convenient for you to know this excellent submersible sewage pump, we will give you a simple explanation with the QW submersible non clogging sewage pump, which is often used. Please look at the following content.　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generatorsDevelopment Curriculum,　　 When adding lubricating oil to the pump at ordinary times, the metering must be controlled,North trudouSelf priming slurry pump wholesale, and the excess lubricating oil in the pump must be discharged and replaced regularly.　　Third, the whole industrial and mining system operates stably, and then place the filler.

　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.where,　　The slurry pump of underground pump can also work normally.　　Clean up the silt and other obstructions in or around the water pump.　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump, the bearing standard, the continuous working time the number of stops and starts of the pump,North trudouDeep well pump, the surrounding environment and the working temperature. Therefore,　　Rotate in the rolling direction until the friction between the impeller and the front guard plate stops, then use the adjusting bolt to move the rotor backward,North trudouRubber lining submerged slurry pump, record the forward and backward movement gap, evenly distribute it between the front and rear guard plates of the impeller until the gap between the impeller, the front guard plate and the rear guard plate is flat, stop, and tighten the two dust discs and fasten them on the shaft. adjustment　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.　　 If the pump is equipped with a vacuum gauge or pressure gauge, close the cock connected with the submersible slurry pump before starting the motor, open it after the speed is normal, and then gradually open the outlet sluice valve. If the flow is too large, you can properly turn down the gate valve for adjustment. Otherwise, if the flow is too small