With the continuous development of slurry pump technology, and of course it can be more than. For example, the maximum design depth of our company&#;s underwater slurry pump can reach m, but such underwater depth is not the best operating depth of this kind of pump, so it will lead to the unreliability of the operation of the vertical slurry pump from time to time.　　Commodity.Tunapuna,　　 The sealing oil chamber of WQ submersible sewage pump is equipped with a high-precision anti-interference water leakage detection sensor, and a thermal element is embedded in the stator winding to automatically protect the pump motor.　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.Kalyan,　　 There may also be mechanical failure of the pump, such as serious damage to the bearing of the pump, so that the bore will be 'swept' when the stator and rotor rub against each other, or the impeller will be stuck due to impurities such as water and grass when the pump pumps water　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.

　　In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is　　The deep well pump works underwater. Taking Hengsheng deep well pump as an example, it has compact structure and light weight. It does not need too long transmission shaft to pump water from the underground. Deep well pump adopts waterproof measures such as mechanical seal or gas seal to keep the interior of the motor dry and free from water intrusion. Hengsheng pump today　　 The pump body (can not) bear the pressure from the outlet pipeline system. The standby pump in the warehouse should rotate (/ times a week to make the shaft bear the load and external vibration evenly. The belt CR drive is that the motor is on the (right) side of the pump from the inlet of the pump.OK or not?　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, it is necessary for us to choose a suitable water pump.　　Rate loss, so shaft power = effective power + lost power.　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, we also need to refer to the instructions when disassembling.

　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improvedtechnical service,TunapunaVortex pump and pipeline pump,TunapunaQJ submersible pump,　　The hardened mud layer collapses after softening avoiding the phenomenon of burying the pump during use.　　Steam will produce air bags, which are harmful to water and seriously damage the vacuum suction. In order to immediately empty the pipe, avoid balloon accumulation. The suction pipe shall be a steep slope rising to the direction of water flow,TunapunaFire deep well pump, rather than an immediate vertical rise, generally exceeding ., which should be the height of the top water pipe along the pump inlet　　It is located in the middle, so it seems that many regions have good effects when using it.Tunapuna,　　Submersible slurry pump is a kind of pump used in mines. Do you know the effect and form of its shaft seal? Let&#;s have a look.　　What is the cause of pump overload.　　The other mechanical seal is a split seal, which can be replaced without disassembling the slurry pump.