Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump, the bearing standard, the continuous working time, the number of stops and starts of the pump, the surrounding environment and the working temperature. Therefore,　　Correct the bent main shaft and adjust the position of the motor and the water pump to make them parallel.　　The seal cannot bear the water pressure at this depth. Once the water leaks, the motor will not work normally, resulting in damage to the submersible slurry pump. The biggest difference between the submersible slurry pump and the horizontal slurry pump and the vertical slurry pump is that the motor of the submersible slurry pump and the shaft connected to the pump are integrated and sealed Closed.Sangjin,　　Water pump After understanding the cause of insufficient liquid supply we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　It is located in the middle, so it seems that many regions have good effects when using it.　　What?

　　Ordinary vertical motor can be used without waterproof, while the motor shaft and pump shaft of submersible slurry pump are coaxial, so the motor must be waterproof and sealed, and the motor and pump can be immersed in liquid at the same time; The vertical slurry pump is an early product, and the submersible slurry pump is a newly developed product according to the market demand　　 Shaft seal part auxiliary impeller shaft seal: through the impeller action of a reverse centrifugal force, prevent the slurry from leaking out. When the positive pressure at the inlet of the pump is not greater than % of the pressure at the outlet of the pump, the single-stage pump or the first stage pump in series can adopt the auxiliary impeller shaft seal, and because the sealing device itself is special it can transport the slurry it can also ensure the internal and external balance of the submersible slurry pump during transportation, so that the pressure at both ends of the equipment can be balanced during normal useManufacturing cost,　　The slurry pump of underground pump can also work normally.　　During the process, the equipment must be regularly maintained and overhauled to avoid blockage. As the name suggests,KomayaguaSubmersible sewage pump, the water pump is mainly used to transport water when it is used. The effect of normal pumps is often better when it is used, but in fact, we use it at ordinary times　　The submersible slurry pump is developed to adapt to the increasingly complex working conditions and facilitate the use of users. Its use mode is more flexible. The equipment has advanced structure, wide flow passage, strong sewage discharge capacity, excellent material selection and strong corrosion resistance. Suitable for conveying liquids containing solid particles, such as sandstone, cinder and tailings. So what are the requirements for its work? Let&#;s understand briefly.

　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.analysis,　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.　　Fiber rope. Perform maintenance,KomayaguaSubmersible slurry pump, replace new bearings and remove debris. In addition, the liquid may corrode the mechanical seal of the submersible pump or the pump body, causing water to enter the submersible pump motor and damaging the submersible pump motor. The effect of using sewage electric pump is good.　　.Komayagua,　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.　　 the water pipe shall be provided with a gate valve to regulate the pump working point. The valve shall be installed as close to the pump outlet as possible. The pump unit greater than meters shall be provided with a check valve at the pump outlet. In case of sudden shutdown, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.