It is also necessary to clean the ventilation duct to avoid blockage.　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.Wells,　　Solution: Please perform parameter initialization (item F and re edit the parameter (possible cause: there is a conflict between item F and item f　　A large amount of lubricating oil is stored.Santa-Barbara-de-Samana,　　The high-pressure water flows to the space occupied by the original bubble at a very high speed, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　 repair and level the welding part of the submersible slurry pump with a file,WellsSingle suction slurry pump,WellsVortex pump and pipeline pump, clean the part to be bound with alcohol again and wipe it dry.

　　If there is a standby pump, it is recommended that the two pumps be used in turn. When the equipment is in use it can pretend that a filter screen plays the role of filtration, so as to avoid a lot of impurities entering the equipment and causing pump jamming.　　 the experimental water shall meet the relevant process requirements.　　Submersible slurry pump Use ultrasonic method to detect whether there is cavitation in the submersible slurry pump. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore, many pumps often have better measurement results when in use.High quality brand,　　Body. So that the pump can realize high concentration transmission without auxiliary devices. The unique sealing device can effectively balance the pressure inside and outside the oil chamber, so that the pressure at both ends of the mechanical seal can be kept balanced, which maximizes the reliable operation of the mechanical seal and greatly extends its service life　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way, we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment and

　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged,WellsScrew deep well pump, there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submergedPrice,　　 There is also a vibration method to measure the vibration frequency of the pump, and the measurement is relatively simple. However, when using one method, the measurement results may have some errors. When using the submersible slurry pump there are other vibration sources that will affect the measurement results, so it is actually the main　　Whether there is any fault.　　 Selection of pipeline diameter: the selection of pipeline shall consider the one-time purchase cost, long-term operation cost and operation reliability.Wells,　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.　　Pump, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.