the cut impeller is usually used. The cut is　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.Guazar,GuazarWQ submersible pump parameters,　　 check the cable and replace it if it is broken or broken to avoid leakage.　　There are many types of submersible slurry pumps available in the market, and different pump models have different performance and application fields. Therefore, although the pump has a wide range of applications, if its model is not correctly and reasonably selected, its application effect will be greatBandirma,　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil,GuazarQuotation slurry pump, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.　　For example, concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant slime and dense medium coal are transported in the coal preparation plant, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.　　The submersible slurry pump shall be shut down for inspection in time in case of machine problems during operation, and regular maintenance shall be done. The equipment will not be used after burning out, which will cause certain economic losses to us.

　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.　　 Use a V insulation resistance meter to measure the insulation resistance between phases and phase to ground of the electric pump motor, the motor stator winding shall be dried, and the drying temperature shall not exceed ℃.　　Work, no noise and vibration, and the site is cleaner.Direct labor,　　In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.

　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.where,　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!　　 Lifting, loading and unloading of electric pump: remove the cable and disconnect the power supply.　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.Guazar,　　According to the user&#;s requirements the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.　　.　　Is called cavitation phenomenon.