Generally, oxygen aylene is used as the gas source and LPG welding tool is used for heating. The torch of the welding tool shall face the joint and then continuously heat the whole joint. This will avoid excessive local heating.Disadvantages: low output, which is the development direction of copper tube industry in the future.Krone,Water quality, water flow and flow of the pipe.In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, and spot prices lacked motivation to rise. The market inventory rose significantly. At that time, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, and the continuous rise of inventory led to the empty market mentality.Maharagama,Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market,KroneRed copper bar, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.Strong connection firmness of copper pipe: the connection between copper pipe and copper fittings is strong.Overview of three production methods of copper tube Copper tube is a very important material for copper materials. There are many ways to complete the production of this copper tube. For copper pipes, the following three methods are generally used to produce materials. The copper tubes produced by these three methods are not only very good in performance, but also very convenient to operate. There are three production methods for copper tube, so what are the three production methods for copper tube?

It is mainly used to manufacture electrical devices such as generators, buses, cables, switchgear, transformers, and thermal conductive devices such as flat plate collectors for heat exchangers, pipes, and solar heating equipment. Common copper alloys are divided into three categories: brass, commonly known as & quot; copper plate& quot;, & amp; quot; red copper plate& quot; or & quot; red copper plate& quot;.Corrosion caused by water with high chloride ion content.Advantages and scope of application of copper tube ground heating At present, ground heating is not only a comfortable heating method, but also a symbol of modern life quality. More and more houses public buildings, sports facilities, industrial facilities and other places begin to use ground heating radiator, copper tubes are selected as the main material of radiator in many places.query,In view of the current overall price difference, the local copper bar price continued to rise at a high level today, while the regions outside East China did not show an obvious follow-up trend, and the local price still has the advantage of price difference with the Northeast and Central China regions. The local inventory pressure will be further reduced due to the small volume of local follow-up goods under the influence of production restriction, and the price support of copper bar is still strong. However, at present, domestic real estate control is still being tightened. The market s expectation of future demand is weakening, and the market s fear of heights appears after the price rises. Today, the market price of copper bars in Shenyang is stable and the shipment is poor.On the other hand, in the steel plant the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising, so the market price has fallen sharply. Subsequently, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However,Krone310s stainless steel round steel, with the decline of black futures,KroneHollow aluminum pipe, the market transaction volume shrank significantly. In addition, the inventory pressure was high traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.The market price of Zhengzhou copper bars is basically stable, and the shipment is not good. In terms of tube blank: today, Shandong Luli tube blank slightly reduced by yuan, and the current mainstream ex factory price is - yuan. In terms of pipe plant: Linyi Pipe Plant locked the price for a week. With a stable market mentality, the factory price of hot rolled seamless pipes is now between - yuan. On the market side: with the arrival of the off-season, traders generally ship goods at a high price. Replenishment is mainly to maintain the existing inventory, and there is no large replenishment plan. The demand is sluggish, and the market price of Zhengzhou copper bar is expected to be stable and declining.

The production method of soft copper tube is basically the same as that of hard copper tube, that is, the annealing process is added compared with the hard copper tube. Annealing of copper tubes means that they are calcined in a high temperature furnace to change the arrangement of the elements in the copper tubes. However, after annealing, the copper tubes will become soft, which makes it easier to bend. The copper tubes produced in this way are called soft copper tubes.total cost,The excellent performance of copper pipe The copper pipe has the characteristics of and, heating and cooling pipes in all residential commercial housing.Corrosion caused by impure copper materials.In addition, it is not easy to be corroded and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected for many times in other places.Krone,Strong connection firmness of copper pipe: the connection between copper pipe and copper fittings is strong.Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.To sum up, due to the influence of factors such as the current spot market price is much higher than the expected winter storage price of merchants, the gradual emergence of supply and demand pressure, and the weakness of raw material support, among which the contraction of market demand has a greater impact. Therefore, the author believes that in the short term, the spot building materials do not have the possibility to rise significantly, and the price of building materials may mainly operate in shock, but with the shrinking demand, However, considering the influence of winter storage and other factors, it is still possible for merchants to lower the spot price in November.