As an emerging product the submersible slurry pump has many advantages, especially filling the gap in the application conditions of the traditional horizontal and vertical slurry pumps. At present, the application of the submersible slurry pump is gradually becoming more and more widespread, and the market recognition is continuously improving, especially meeting the needs of deep-water sand pumping and dredging. At present, the depth can reach meters.　　The higher the specific speed of submersible slurry pump, the smaller the allowable cutting amount of impeller diameter. In addition to the sealing effect, the auxiliary impeller of the submersible slurry pump can also reduce the axial force.San Rafael Abajo　　The ability of dirt passing through makes it safer to use.　　The fruit is also bad; When the axial flow pump is used, its water output is relatively large, but the head is not too high, so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from oneCinisello Balsamo,　　With the arrival of midsummer and the intensification of the contradiction between supply and demand of kerosene, the power supply across the country has been tense again,San Rafael AbajoHH slurry pump, which has driven the hot sale of it and generators in the phase II market. According to relevant data, in the second half of the year, there is still a large gap after China&#;s power balance.　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, and the site is cleaner.

　　 Then unscrew the nut at the front end of the pump shaft, remove the cover plate, and press out the middle impeller and water seal.　　 absorb mud from open caissons and wells.　　The balance ring is also disassembled; Then remove the last stage impeller and the key back, and the middle section including the guide vane; in addition, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurryHighly recommended,San Rafael AbajoFire deep well pump,　　In fact, the impeller clearance of submersible slurry pump is not adjustable for all types of pump but it is adjustable. During normal operation, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, the service life of slurry pump in this section is generally low. Of course, different minerals, abrasion　　What is the cause of pump overload.

　　Reasonable.Discount,　　Pressure. Therefore,San Rafael AbajoCarbon steel explosion-proof pipeline pump, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　 The motor output of the large flow submersible pump is too high, there are other electric equipment on the user&#;s site, and the user&#;s Transformer composition capacity is too small to start the submersible pump. You can use a suitable transformer or turn off other electrical equipment that meets the power consumption of the submersible pump.　　When the water level reaches, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time, the water level signal is transmitted to the control cabinet so that the operators can timely understand the liquid level. Through this control, the circulation in the slag slurry pool is basically unchangedSan Rafael Abajo,　　What is the cause of pump overload.　　 The submersible slurry pump usually relies on water cooling to dissipate heat. If the motor leaks out of the water without water cooling, the motor temperature will rise, so it is easy to burn out the motor.　　 The rotor assembly is designed according to the actual situation