H-section steel belongs to high-efficiency and economic cutting profile (other cold-formed thin-wall section steel, profiled steel plate, etc.). Due to the reasonable section shape, they can make the steel give more play to its performance and improve the cutting capacity. Different from ordinary I-type, the flange of H-section steel is widened, and the inner and outer surfaces are usually parallel, so it is convenient to connect with other components with high-strength bolts. Its size composition is reasonable, series and models are complete,JonkielHigh pressure alloy pipe, which is convenient for settingDefects of alloy pipe and solutions:Jonkiel,Classification by section shape The defects can be removed by grinding with sand wheel,GB No. I-beam is in height, in leg width and in waist thickness.Its heat sealing effect is remarkable. It can be directly buried immediately which can not only save resources, not occupy the natural environment, but also purify the environment. The transportation of gas can meet the requirements of long-distance transportation, prevent actual operation and maintenance, meet the requirements of thermal insulation and cold protection, reduce heating equipment,JonkielPrice of reinforcement sleeve, unique and convenient installation, and reduce the construction cycle time of the project. On the whole, smooth surface, strong adhesion, no zinc scar, no zinc leakage and high dimensional accuracy. All surfaces are wrapped by zinc layer, and the zinc content on the surface is usually -g /? It has long service life, corrosion resistance and durability. It is a kind of stronger protection.Home page recommendation,Plan scheme : for high carbon steel with carbon content of more than .% and high chromium alloy pipe with chromium content of no less than %, the interval is min.Due to the unique performance of I-beam, I-beam has successfully solved the problem of serious equipment wear in many industries.Classification introduction

Application scope of alloy pipeProject scope, Remove defective pipes within the allowable length.Galvanized pipe: the zinc layer of cold galvanized pipe is an electroplating layer, and the zinc layer is separated from the steel pipe substrate. The zinc layer is very thin. The zinc layer is simply attached to the steel pipe substrate and is easy to fall off. Therefore, its corrosion resistance is poor. In new homes, it is forbidden to use cold galvanized pipes as water supply pipes.The specification of pass design I-beam is expressed in cm of waist width. For example, the waist width of No. I-beam is. The types of I-beam include hot-rolled ordinary I-beam, light I-beam and wide parallel leg I-beam (H-beam). The waist width of hot-rolled ordinary I-beam in China is ~,Jonkiel219 how much is a ton of seamless pipe, expressed as No. ~ No., and the inclination of inner wall of leg is : The pass system of rolled I-beam includes direct pass system cross pass system and mixed pass system. In addition, I-beam can also adopt special rolling method.Jonkiel,The delivery length of I-beam is divided into fixed length and double length, and the allowable difference is specified in the corresponding standards. The length selection range of domestic I-beam is divided into -, - and - according to different specification numbers. The length selection range of imported I-beam is generally -.Heating surface tubes for low and medium pressure boilers (working pressure is generally not greater than MPA and working temperature is below ℃); Special rolling method. When it is difficult to roll the required I-beam by the usual rolling method for some reason the special rolling method can be used to make full use of the skills of uneven deformation and pass design. For example, when the billet section is narrow and wide I-beam is required to be rolled, the wave rolling method can be used; for example, when the billet is wide and small I-beam is required to be rolled, the negative rolling method can be used Spread rolling, etc.