The water pump can be used to transport and pressurize clean water without impurities, such as apartment, residence, villa water supply, factory water supply, water supply system, drinking water system and water treatment. In short, there are many uses.　　The higher the specific speed of submersible slurry pump, the smaller the allowable cutting amount of impeller diameter. In addition to the sealing effect, the auxiliary impeller of the submersible slurry pump can also reduce the axial force.Tomazo,　　Required lift (m)　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.Dubti, it has a rapid development momentum although the absolute number of submersible slurry pumps has not exceeded that of vertical slurry pumps, mainly due to the convenience and flexibility mentioned above; In addition, for submersible slurry pump　　If there is a standby pump, it is recommended that the two pumps be used in turn. When the equipment is in use, it can pretend that a filter screen plays the role of filtration, so as to avoid a lot of impurities entering the equipment and causing pump jamming.

　　Strong strength and other advantages. It is widely used as a sealing device for various pumps. Place a water seal ring at the bottom of the packing box, and then place the filler.　　 Low vibration and noise, low motor temperature rise, no pollution to the environment.　　Some impurities will entangle the impeller, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.Inspection items,　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.　　After meters, the sealing of the equipment can not bear the water pressure at this depth.　　Will be scrapped. In addition, since the length of the long shaft is generally fixed,TomazoBaigang deep well pump,TomazoCarbon steel explosion-proof pipeline pump, the installation and use of the slurry pump submersible are troublesome and the application occasions are limited. It is normal to use the equipment for a long time, for example, when the submersible slurry pump is used at ordinary times, air holes usually appear

　　 The working properties of the two pumps are also different. Because the sewage pump is driven by a motor, it generally has good voltage impact resistance. The submersible pump is of the type of quick opening and quick closing, so it usually uses some small Flow and small pressure.Management Department　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump, we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latent　　If the sewage contains fiber objects such as gloves, when the submersible slurry pump is blocked during use　　In fact, it will not only have a certain impact on the working efficiency of the equipment during operation, but also cause serious damage to the equipment itself,TomazoISG single stage vertical pipeline pump, so it is also a reminder that we are using it tooTomazo,　　The other mechanical seal is a split seal, the motor will not work normally, resulting in damage to the submersible slurry pump. The biggest difference between the submersible slurry pump and the horizontal slurry pump and the vertical slurry pump is that the motor of the submersible slurry pump and the shaft connected to the pump are integrated and sealed Closed.　　 If the power cord is not well contacted, it will also lead to the burning of the motor.