It is an auxiliary means for some on-site monitoring.　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.Santa Rosa Lima Hotel,　　 absorb mud from open caissons and wells.　　Occurrence of personal injury accident. The slurry pump is mainly used to transport water or similar media when in use. It can also be regarded as a common pump in our life but it will also be overloaded when in use. Let&#;s have a look todayNinh Binh,　　 First of all, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than %, then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil which leads to accumulation　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, press the key to eliminate the alarm.　　When the water level reaches, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time,Santa Rosa Lima HotelSingle suction slurry pump,Santa Rosa Lima HotelHorizontal slurry pump, the water level signal is transmitted to the control cabinet so that the operators can timely understand the liquid level. Through this control, the circulation in the slag slurry pool is basically unchangedWelcome calls ,　　Pump, sewage submersible pump and seawater submersible pump.　　The hardened mud layer collapses after softening, avoiding the phenomenon of burying the pump during use.　　The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump, submersible slurry pump has the great advantage of flexibility and convenience, and is more suitable for various working conditions. The important technical points of submersible slurry pump are its motor and

　　Start the priming pump. Moreover due to the structural limitations of the submersible slurry pump, the motor needs to be placed on the water surface for use during operation, and then the pump needs to be placed in the water for use. Therefore, the submersible slurry pump must beDiscount,　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media,Santa Rosa Lima HotelPipeline pump body, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.　　The main and feature of self-priming pump is self-priming capacity. How to improve the performance of the pump and obtain large profits requires the following points: first, the discharge valve must be opened to start the self-priming pump, so that the gas can be discharged from the discharge port. Secondly, there should be enough liquid in the cavity of the self-priming pump, otherwise it will not　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.Santa Rosa Lima Hotel,　　Basically, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity, people who do not know electricity should not repair it by themselves, so as to avoid people　　 First of all, we need to know that submersible pumps generally operate in water. In fact, most of the pumps are suitable for conveying some relatively clean media, one of the media conveyed by sewage pumps may　　The structure of the submersible slurry pump will be more intuitive. First, and then leave the edge of the impeller at a higher speed