KanasFire deep well pump,

　　Stability and reliability of seals between pump bodies.　　Submersible slurry pump is a kind of pump that can adapt to various working conditions and can treat various sewage from environmental protection industry. Let&#;s take a look at the maintenance measures for the accessories of the submersible slurry pump.Kanas,　　 The casing ground wire of the electric pump shall be connected in strict accordance with relevant regulations. When the electric pump is running, it is strictly prohibited to work or move in the water of nearby devices or people, in case of accidents caused by the power distribution of the electric pump.　　It can improve the mechanical efficiency to a certain extent. Moreover, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use,KanasSewage pump diving, and also reduce the corrosion and rust as much as possiblePerico,　　 If the hot water within ℃ is recommended, the hot water pump must be used and the external tap water shall be connected for cooling during operation, otherwise the motor will not be burned due to too high medium temperature.　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　If the shaft seal is not properly selected, it will not only require frequent maintenance during operation, but also leak a large amount of transmitted liquid.

　　 The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage!　　Or nodular cast iron, vertically split, bolted. The pump body is connected with the bracket with bolts. The discharge outlet of the pump can be rotated and installed at intervals of ℃ and eight angles as required.　　 add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is fullquality standard,　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, and check the impeller. In case of damage or aging, it needs to be replaced in time,　　 one method is to use ultrasonic method to detect whether the equipment has cavitation. This method is often convenient for re detection. Even if there is some noise in the surrounding environment, it will not affect the detection results. Therefore many pumps tend to have better measurement results when in use.　　 Then unscrew the nut at the front end of the pump shaft, and press out the middle impeller and water seal.

　　Under the action of auxiliary devices, it can transport the slurry, and because the sealing device itself is special, it can also ensure the internal and external balance of the submersible slurry pump during transportation, so that the pressure at both ends of the equipment can be balanced during normal useDirect material, Ritter pump will provide you with high-quality slurry pump products; New progress in submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　 Lifting, loading and unloading of electric pump: remove the cable and disconnect the power supply.　　In addition to the method,KanasSubmersible pump can pump sewage, materials shall be selected comprehensively according to the nature of corrosive medium, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, which should be a comprehensive optimization design method.Kanas,　　The motor is scrapped. Moreover, because the length of the long shaft is generally fixed, the installation and use of the pump is troublesome and the application occasions are subject to many restrictions.　　If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.