RimuskyDouble suction slurry pumpFormal specialty
2023-01-21 00:12:57One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When After each use of the equipment,RimuskyVertical slurry pump, allowable maximum outer diameter of downhole part of pump mm Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops,RimuskyNon clogged pipeline sewage pump, and pay attention to the temperature rise outside the packing chamber.Wolmaransstad, When the power supply voltage is too low, the pump will be overloaded, because the pump is also widely used in many rural watering. In this case, it may be lower than the rated voltage, so the current in the stator winding will also be If the pump is equipped with a vacuum gauge or pressure gauge, close the cock connected with the submersible slurry pump before starting the motor, open it after the speed is normal, and then gradually open the outlet sluice valve. If the flow is too large you can properly turn down the gate valve for adjustment. Otherwise, if the flow is too small,Open the gate valve. When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows
Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet, that is, the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point. And it shall be used according to the quota specified in the manual. Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.Quality improvement, When the submersible slurry pump is used at ordinary times cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times? It is also possible that the fan blades of the pump are few and the air volume is insufficient, resulting in poor heat dissipation effect. The whole packing body, including the packing gland, packing ring and packing, shaft sleeve, and then the discharge section includes the last stage guide vane
Commodity.Recommendation and consultation, Yes, such mechanical faults will cause the stator winding of the pump to be burnt out. Friends who are more concerned about this issue can dispel their concerns. The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.Rimusky, Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller the front and rear bearing glands are equipped with oil seals, which are padded with green paper or asbestos. There is a gap of .- mm between the rear gland and the bearing. Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.