We also need to limit the starting frequency and select appropriate thermal protection devices for use.　　Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet, that is, the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point.Matamoros,　　(a) The altitude shall not exceed m.　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, and then a filter screen is installed in the trap to filter impurities for the second time, so as to avoid the blockage of the submersible slurry pump during use.Meru,　　When the slurry pump is working, the pump needs to be placed on land, the suction pipe in water, and the pump needs to be started. Due to the structural limitations of the mud pump and submerged slurry pump, and the pump must be fixed when it is put into the water. Otherwise, the motor will fall into the water　　So it is called: submersible slurry pump.　　The fruit is also bad; When the axial flow pump is used, its water output is relatively large,MatamorosVortex pump and pipeline pump, but the head is not too high so the effect of using the submersible slurry pump in many plain areas is also relatively good; The water output and head of the mixed flow pump are actually derived from one

　　After meters, the sealing of the equipment can not bear the water pressure at this depth.　　 estimated installation depth of pump M　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, and then a filter screen is installed in the trap to filter impurities for the second time　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, so as to avoid the blockage of the submersible slurry pump during use.　　When using the submersible slurry pump we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　The water pump can be used to transport and pressurize clean water without impurities, residence, villa water supply, factory water supply,MatamorosVertical slurry pump, water supply system, drinking water system and water treatment. In short, there are many uses.

　　 Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate, drive the solid flow, and realize the transportation of slurry.Honesty and mutual benefit,　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.　　 Temperature control: an external temperature controller is used to turn on or off the pump according to the set temperature range. It is used in constant temperature, heat exchange system and other occasions requiring temperature control.　　 If the head of the submersible slurry pump is too low or the head is higher than the practical condition, the flow will be large and the current will rise. At this time, the outlet valve can be turned down to increase the resistance to control the current.Matamoros,MatamorosQuotation slurry pump,　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump, the bearing standard, the continuous working time, the number of stops and starts of the pump, the surrounding environment and the working temperature. Therefore, it is necessary to gradually accumulate the experience and add smooth oil in a reasonable and timely manner.　　Fourth, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.　　Yes, summer is the peak sales season. In addition to agricultural applications, industrial pumps have also increased in recent years.