Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an, Jiangyin and Lecong, the inventory level remains relatively moderate, and the pressure on the market is relatively small. In Wu an market, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.The room temperature tensile strength of the annealed red copper sheet is ~ kgf/mm, the elongation is ~% and the Brinell hardness (HB) is ~RAH,Heat and insert the copper tube and sleeve, and move the flame nozzle back and forth continuously between two points. Do not touch the flame directly with the flux. When heating steel pipes, and copper ions can be separated by conductivity, so that copper tubes can be produced with the separated copper ions. This method is very complex, requires high technology and new equipment, so only advanced foreign countries can use this production method.San JoaquinAt present, the fundamentals faced by the domestic copper bar market are still mixed. On the one hand, the market supply is expected to shrink, but on the other hand, the northern market has entered the off-season of demand, and the market s expectation of future demand is pessimistic. In the short term, domestic steel prices will enter the operating track of range consolidation. To sum up, considering the current situation of demand and inventory in the steel market, it is difficult for the steel market to make a breakthrough. As the th National Congress of the Communist of China is approaching, environmental protection phenomena such as steel mills are still going on, and businesses can operate flexibly on a short-term basis, and the shipment transaction is * * *.Generally, oxygen aylene is used as the gas source and LPG welding tool is used for heating. The torch of the welding tool shall face the joint and then continuously heat the whole joint. This will avoid excessive local heating.The hard copper tube is not artificially treated after being drawn or extruded, so that it can be naturally formed. At this time, the organizational form in the copper tube is full. This kind of copper tube is more likely to crack and is not suitable for bending. Therefore the hard copper tube is generally straight.

If you want to make the copper surface become bright again, you can polish it with copper point solution. It can not only make the copper surface brighter, but also quickly remove the rust and oxide layer on the copper surface to restore the luster of the copper itself.The copper pipe has high welding precision, fast production speed, good surface finish and beautiful appearance. Therefore, it is widely used in precision welding industries such as glasses, hardware, electronics accessories, sanitary ware and kitchenware.After : on October , continue to implement the measures of stopping and limiting production specified in TZBZ [] No. document. All sintering machines and shaft furnaces using wet desulphurization in iron and steel enterprises in the city were shut down, and sintering machines using semi dry desulphurization continued to be shut down for %. The access of vehicles is alicted. The port collection and distribution vehicles are prohibited from entering and leaving the port area. The city s steel, coking, electric power, cement,RAHCopper aluminum composite row, chemical and other key vehicle enterprises are not allowed to transport vehicles into and out of the plant. After : on October , the vehicle enterprises in the above industries will implement % of the peak load shifting emission reduction measures. It is estimated that the average daily consumption of sintering powder in Tangshan will be more than yuan, and the purchase of iron ore may still maintain a small amount of prudence. In addition, due to the influence of industrial users & amp; quot; coal to gas& quot;, the recent performance of coke is weak. Therefore, in terms of steel plant production, the support of raw materials is weak.Marketing Department,First of all, we should set up a warehouse. The temperature in the warehouse should be generally kept at - ° C, while the humidity should be normal. The room should be kept ventilated.The production method of soft copper tube is basically the same as that of hard copper tube, that is, the annealing process is added compared with the hard copper tube. Annealing of copper tubes means that they are calcined in a high temperature furnace to change the arrangement of the elements in the copper tubes. However, after annealing, the copper tubes will become soft, which makes it easier to bend. The copper tubes produced in this way are called soft copper tubes.The copper bar market declined steadily this week, with a decline of - yuan. Due to low pig iron inventory, some steel mills in Jiangxi have resumed purchasing recently, but the purchasing volume is not large. The purchase price of pig iron in Yunnan steel plants was slightly increased to ensure the purchase volume due to the low purchase price of pig iron in the early stage. Recently, the steel market has been in shock and adjustment, and the merchants are unstable. Steel mills in Hebei, Tianjin and other regions have stopped producing pig iron for steelmaking. Now, it is mainly expected to make inquiries. However, due to the lower price of raw materials, the price of iron mills has been lowered.

The excellent performance of copper pipe The copper pipe has the characteristics of and, which makes it a suitable choice for modern contractors to install water pipes, heating and cooling pipes in all residential commercial housing.Encyclopedic knowledge,Overview of three production methods of copper tube Copper tube is a very important material for copper materials. There are many ways to complete the production of this copper tube. For copper pipes, the following three methods are generally used to produce materials. The copper tubes produced by these three methods are not only very good in performance, but also very convenient to operate. There are three production methods for copper tube, so what are the three production methods for copper tube?Copper is light.At the opening this morning,RAH310s stainless steel coil, the market price of Zhengzhou copper bar was basically stable. According to the monitoring data of the Lange cloud business platform, the current market price of * mm Linyi copper bar was yuan (ton price, the same below), the * mm copper bar was yuan,Among the three production methods of copper tube, the oxidation method is the most. Because as long as the metal copper is oxidized by the anode and the copper ion of the anode is attached to the tube material, the copper tube can be produced. Thisthod is also the most common method to produce copper materials. It has not only been used for a long time but also has a mature technology, which is to produce copper tubes through oxidation reaction. This production method is the main production method of copper tubes in China.Later, Mexican scientists also found that copper has a . Recently, British researchers found that copper has a strong bactericidal effect. It is believed that in the near future, copper will make great contributions to improving human health. Copper plate T is named after its purple color. It is not necessarily pure copper, sometimes it also involves a few deoxidizing elements or other elements to improve raw materials and s, so it is also included in copper alloys. The processed materials of Chinese cor plate can be divided into four categories according to the composition: ordinary copper plate (T, T, T, T, oxygen free copper plate (TU, TU and high-purity, vacuum oxygen free copper), deoxidized copper plate (TUP TUMn), and special copper plate (arsenic copper, tellurium copper, silver copper) with a few alloy elements added. The conductivity and thermal conductivity of copper plate are second only to silver, and are widely used to manufacture conductive and thermal conductive devices. The red copper belt has outstanding corrosion resistance in the atmosphere, sea water, some non oxidizing acids, salt solutions and a variety of organic acids (aic acid,RAHT2 copper bar, citric acid) and is used in the chemical industry. In addition, the output value of copper plate exceeded that of other copper alloys.In August, the price of domestic medium and heavy plates fell sharply. As of August , the price center of ordinary carbon boards in leading cities had dropped to , down yuan/ton from the end of July. At the beginning of the month, affected by the macro bad news, and the recent poor performance of fundamentals, the market mentality turned to pessimism, and some traders shipped at low prices. The market inventory rose, the inventory pressure was high, the stock shortage phenomenon disappeared, and the market transaction atmosphere was cold, the demand performance continued to decline, and the spot price fell under pressure.