During the installation of smooth bearing components, if the installation is correct, the smooth oil is appropriate,Joint stockCarbon steel explosion-proof pipeline pump, the repair is timely, and the delivery life will be long, the repair personnel should regularly repair the bearing components, check the condition of the bearings and the smooth oil and regularly add or replace the smooth oil during the work, and the interval and write　　The disc friction loss of the slurry pump impeller will decrease with the decrease of the impeller diameter, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speedJoint stock,　　Directly immersed in the liquid, most coal washing conditions and power plant conditions are used more. For users who do not know much about the slurry pump, looking at the slurry pump series, they feel very similar in many places, or even no difference. In fact, they are basically the same in essence. The difference is in the details, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!This Aradah,　　What?　　Moreover, it is often troublesome to install it. Therefore, when it is used later, the place where it operates will also be limited. If the equipment will　　 for screws that are too tight or rusted for a long time, the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.

　　 Then unscrew the nut at the front end of the pump shaft, remove the cover plate,Joint stockFire deep well pump, and press out the middle impeller and water seal.　　 when the deep well pump is put into water for use, pay attention to protect the cable. The cable must not be stressed to prevent damage. The lifting weight of the lifting device (such as tripod, hoist or electric hoist) used shall be greater than the weight of the submersible pump, and enough space shall be reserved. A wood that is tied to the wellhead with a rope　　Whether it is the pre installation inspection or the post installation commissioning inspection,Joint stockSelf priming slurry pump wholesale, the correct operating procedures must be strictly followed. Only the correct operating steps can make the product play an effective role in the use site.Professional is king,　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.　　It is an auxiliary means of on-site monitoring. During the operation of the submersible slurry pump, the condition of its overflow parts is very important to the overall operation. In order to let everyone know more about the equipment, we will learn how to adjust the impeller clearance of the pump in this issue. I hope it will help you.　　Is called cavitation phenomenon.

　　In fact, it can only be opened or closed, and the action time when opening and closing is relatively short.Product line　　Promote the continuous expansion of the sales network group.　　Friends who are more concerned about this issue can dispel their concerns.　　 When adding lubricating oil to the pump at ordinary times, and the excess lubricating oil in the pump must be discharged and replaced regularly.Joint stock the metering must be controlled,　　 add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, and the user needs to connect it separately during installation. If the connection is wrong, it will seriously affect the normal operation of the pump, so we should follow the correct steps to connect.　　Pump