inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full　　What is the solution to this situation?Delamondville,　　 Clean water pipeline single-stage single suction pump. It is used for high-rise building water supply, heating, industrial and domestic water supply and drainage, pressurization, industrial pipeline pressurized transmission, cleaning, refrigeration and air conditioning cycle, water supply equipment and boiler accessories. The operating temperature should be controlled below ℃.　　This phenomenon shows that the failure of the pump is not only a material problem, but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanicsLoa Janan,　　The installation of submersible slurry pump is a step that needs to be concerned. Since we all care about it, it is mainly because the installation will directly affect the use effect. The installation work should be seamless. Some key operating points can be seen when installing the slurry pump.　　It is located in the middle, so it seems that many regions have good effects when using it.　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water, otherwise the mechanical seal will be burned.

　　 The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.　　 Pipeline single-stage single suction hot water pump. It is an IRG type single-stage single suction hot water pipeline pump with ring conveyor belt for high-temperature hot water boilers in metallurgy, chemical industry, paper mills, timber, restaurants, textiles, bathrooms, hotels and other departments. The operating temperature is generally not more than ℃.　　Rate.OK or not?,　　The of descending axial force can be used for slurry transportation in power plants, hydraulic and other professions; The mechanical seal is tight and reliable and the leakage probability does not exceed drops /min, which is mostly used to transport flammable, explosive, toxic,DelamondvilleSplit vertical pipeline pump, strong corrosive and valuable liquids or materials with high temperature, high pressure and low temperature.　　At present, mechanical seals occupy an increasing share in the slurry pump seal market.　　Work,DelamondvilleSmall deep well pump, no noise and vibration, and the site is cleaner.

　　 Why does the demand for submersible slurry pumps increase greatly? From the perspective of market demand,DelamondvilleRubber lining submerged slurry pump, although the number of submersible slurry pumps has not exceeded that of vertical slurry pumps, it has a rapid development momentum. The main reason is that the above-mentioned use is convenient and flexible; In addition, the application market of submersible slurry pump is also better than that of vertical pumpPrice,　　 the submersible slag pump is often used to transport pulp containing solid particles so the wear resistance of the pipeline should also be considered.　　The key to the problem should be to fundamentally solve the problems of pump sealing and overload, we applied the hydrodynamic seal technology of the auxiliary impeller and the non overload design technology of the pump to the submersible sewage pump which is a more active method. Therefore, which greatly improved the pump seal　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.Delamondville,　　What stands out is the sealing of the container. The seal is easy to install and maintain, but the price is quite expensive.　　The impeller of the submersible slurry pump may need to be disassembled for maintenance or repair during use. However, when we do not know the pump structure, it belongs to a portable workstation, which can be brought wherever it is needed, because it does not need too many auxiliary facilities.