HondurasDrilling fluid slurry pump,

　　Fourth, model selection parameters: outlet diameter, flow, motor power, impeller speed, pumping rate, maximum particle and weight.　　The submersible slurry pump is a slurry pump which is connected with the motor and works under the water at the same time. Compared with horizontal slurry pump and vertical slurry pump,HondurasDeep well pump, the biggest advantage is that it is flexible,HondurasScrew deep well pump, convenient and easy to apply to various working conditions. The most important technical point of submersible slurry pump is the tightness between its motor and pump body Stability and reliability of seals.Honduras,　　This series of slurry pumps have wide range, good cavitation and high efficiency. Flow passage parts have good wear resistance. Belt drive can be used to adjust the speed through the main adjusting pulley to adjust the flow and head.　　So it is called: submersible slurry pump.Yirga Alem,　　For example in the market, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　 confirm whether the pressure capacity of the pipeline meets the requirements and conduct hydrostatic test if necessary.　　When the submersible slurry pump is used at ordinary times, cavitation usually occurs which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?

　　How to avoid this situation when the equipment is in use.　　The submersible sewage pump is a kind of pump product which is connected with the motor and works under the water at the same time. Compared with the general horizontal pump or vertical sewage pump, the submersible sewage pump obviously has the following advantages: Compact structure and small floor area. Submersible sewage pump is submerged　　Some of them are OK. For irrigation and other purposes, in fact, we choose to use larger flow. Let&#;s take a look at the method of selecting pumps.Latest consultation,　　The above is the reason for the insufficient liquid supply of the water pump when it is in use, as well as the specific methods to deal with this situation. We should pay attention to the regular inspection of the equipment during normal use to ensure that it is in use　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!　　Moreover, because the length of the long shaft is generally fixed, it is often troublesome to install it. Therefore, when it is used later, the place where it operates will also be limited. If the equipment will

　　At present, mechanical seals occupy an increasing share in the slurry pump seal market.Inspection items,　　What?　　Fire pump control cabinet generally has two control modes: one is fire hydrant control, and the other is spray pump control. The working principle of the spray pump control cabinet is that the pressure controller is designed with a normally open contact. When the pressure relay acts due to the pressure difference, the control circuit moves the main circuit　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.Honduras,　　Let the medium containing some solid particles generate a certain flow rate, so that the equipment can drive the solid to flow when it is in use, so that the slurry can be transported. In terms of the principle of the submersible slurry pump, it is actually quite simple　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　If the oil seal ring of the shaft is seriously worn, replace it with a new one.