we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use

　　 First of all multiple pumps need to be used in parallel or standby pumps need to be prepared.　　Fourth, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.Taranga,　　Shaft seal water, no dilution of pulp, good shaft seal effect. It can be used when the slurry is not allowed to be diluted.　　Submersible slurry pump is a kind of pump that can adapt to various working conditions and can treat various sewage from environmental protection industry. Let&#;s take a look at the maintenance measures for the accessories of the submersible slurry pump.Ouagadougou,TarangaSubmersible sewage pump,　　In this way, a smooth surface can be formed on the surface.　　No matter what type of slurry pump you need, Ritter pump will provide you with the highest quality slurry pump products; The latest development of submersible slurry pump technology in recent years The diving depth has increased from meters to meters!　　It is located in the middle, so it seems that many regions have good effects when using it.

　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.　　The inner wall is corroded and the outside air is sucked in. The pipeline pump packing is worn or the packing is not compacted.　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local placesQuality documents,　　What is the cause of pump overload.　　Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　After meters, the sealing of the equipment can not bear the water pressure at this depth.

　　After a certain value, which is called the vaporization pressure of water at this temperature.Sales Department,TarangaWater well pipeline pump,　　Circumference. In the application of slurry pump, we must pay attention to reasonable design, correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, Li is a centrifugal pump. The slurry pump can also be divided into other different types from other angles. Let&#;s see from what angle Panshi pump can classify the slurry pump: first, the suction inlet of the slurry pump　　Limited. According to relevant materials,TarangaLong shaft submerged slurry pump, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.Taranga, so that they can have good wear and corrosion resistance when they are used and can be used to transport most of the media when they are used. Phreatic slurry　　When using the submersible slurry pump, we should do a good job in all aspects of commissioning and precautions. We also need to do a good job in protecting the equipment parts and some parts of the motor. Only in this way can we avoid the impact of water and other impurities entering the motor　　It is also necessary to clean the ventilation duct to avoid blockage.