Please note that there should be a space of over mm left on both sides of the escalator, and when arranged in parallel,JiexiuAluminum alloy movable lifting platform, there is no restriction between the two escalators.Machine room power supply: The power supply should be three-phase V, and the lighting power supply should be single-phase V,JiexiuHydraulic unloading and tipping machine, HZ. The incoming line should be connected to the vicinity of the machine room entrance and equipped with an incoming socket. Specializing in product and renewable resource business, including: home elevator manufacturersJiexiu,Elevator Tip : Why elevators can trap people? Every elevator door on each floor has a safety switch, like braking to stop.Maintenance of elevator hall doors and car doors. Elevator malfunctions usually occur on the elevator hall and car doors, so attention should be paid to the maintenance of the hall and car doors. One is to refuel the fuel on the upper sill of the door and keep it in good condition,JiexiuHousehold villa small elevator manufacturer, so that the elevator will not make unpleasant noises during operation and the opening of the door. Pay attention to the inspection of the safety contact plate or light curtain type contact plate switch wire of the elevator, as the frequency of opening and closing the door in the elevator is high, which can cause damage to the switch wire. This requires maintenance personnel to inspect it every time they work, and replace it in advance to avoid users having doubts about the quality of the elevator product due to door issues.Beit Zabde,To implement the arrangement of escalators and provide feedback, in order to determine the configuration of certain shared devices, the order of shipment, and the alignment of handrail turns during continuous arrangement.The call button on each floor is no longer working, and when arranged in parallel, there is no restriction between the two escalators.Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runwayThe safety monitoring machine room environment screen cabinet main power switch traction wheel speed limiter shaft and pit guide rail layer door and car counterweight should be reliably fixed with pressure plates to prevent loosening.total cost,The beam edge distance is too small: The method of shortening the lower platform is to shorten the total length of the escalator, but note that the range of shortening is very limited, generally not exceeding mm. Generally, the platform cannot be shortened because it contains equipment such as cabinets and motors. Change the angle of the escalator from degrees to degreesThere is a dedicated fire telephone in the fire elevator car.The household must make two steel splints above the entrance. The position and size of the clamp plate are determined based on the selected door machine model.

The household must make two steel splints above the entrance. The position and size of the clamp plate are determined based on the selected door machine model.Industry management,During the use of elevators, some elevator users seek temporary workers or unqualified companies for elevator maintenance in order to reduce costs and save funds. Once safety issues arise even the responsible unit cannot be found. If the maintenance is carried out by elevator manufacturers or qualified professional companies, on the one hand, the maintenance technology and quality are guaranteed, and on the other hand, if any problems occur, someone is also responsible.The seat elevator person sits on a chair driven by an electric motor, and the button on the chair handle causes the power drive device at the bottom of the chair to drive the person chair up and down along the guide rail of the staircase railingCleaning and cleaning of elevator car guide shoes. As is well known, the guide shoe runs on the guide rail and there is an oil cup on the guide shoe. To ensure that the elevator does not make any noise during operation, it is necessary to regularly refuel the oil cup and clean the guide shoe, and the cabin should be cleaned thoroughly.Jiexiu,Restore the command button function in the cabin for firefighters to operate.Measure the beam edge distance between the upper and lower support beams. The measurement is to suspend the line from the upper support point to the ground for positioning, and then measure the horizontal distance from the positioning point to the edge of the lower support beam.The front room of the fire elevator is equipped with Class B fireproof doors or fireproof rolling shutters with stopping function.