Adjust the ratio of austenite forming elements to ferrite forming elements in the steel to make it have austenite + ferrite dual phase structure, in which ferrite accounts for % - %. This dual phase structure is not easy to produce intergranular corrosion.With the implementation of China's reform and opening up, the national economy has achieved rapid growth, and a large number of urban houses, public buildings and tourism facilities have been built, which puts forward new requirements for hot water supply and domestic water supply. In particular, people pay more and more attention to the problem of water quality, and the requirements are also increasing. Galvanized steel pipe, a common pipe,JarucoStainless steel pipe threading, will gradually withdraw from the historical stage under the influence of relevant countries because of its corrosivity. Plastic pipe, composite pipe and copper pipe have become common pipes in the pipeline system. However, under certain circumstances, stainless steel pipe has more advantages, especially the stainless steel pipe with wall thickness of only . ~ mm. In high-quality drinking water system, hot water system and water supply system that puts safety and sanitation first, it has the characteristics of safety reliability, sanitation, environmental protection, economy and applicability. It has been proved by engineering practice at home and abroad that it is one of the new, energy-saving and environmental protection pipes with good comprehensive performance of water supply system. It is also a very competitive water supply pipe, which will play an incomparable role in improving water quality and people's living standards.Jaruco,Choose the price.Austenitic stainless steel can be used to manufacture stainless spring, clock spring and steel wire rope in aviation structure after deformation strengthening. If welding is required after deformation, spot welding process and deformation can only be used to increase the tendency of stress corrosionCoimbra,After fine tuning the molten steel temperature in the argon blowing station, it is lifted to the ladle rotary table for continuous casting.For business people, of course, we can often see that there will be packaging film bags on them. Although they are not heavy, if there are a large number of single purchases, they will also produce certain economic expenses, but why do many people clearly dislike this thing on stainless steel pipes, But I have to accept it. Next, xincoral Xiaobian will tell you why stainless steel pipes need packaging bags.Water preparation, storage, purification, regeneration, seawater desalination and other water industry excellent materials. The demand is about tons.

Crimping: during crimping,JarucoStainless steel braided belt, the convex part of the pipe fitting is placed in the concave groove of the die, and the jaw is perpendicular to the pipe axis.h chemical composition carbon C: Manganese Mn: silicon Si: chromium Cr: nickel Ni: phosphorus P: sulfur s: niobium NB: h stainless steel Name: austenitic stainless steel standard: aisastm model: huns No.: Note: a single value is a high value unless otherwise indicated; when used in some pipe making processes, the nickel content of some models of austenitic stainless steel must be slightly higher than that shown in the table; optional High TA content is .%; high content is .%; high content is the basic characteristics of stainless steel, with high temperature strength and high temperature plasticity, excellent oxidation resistance and corrosion resistance, good structural stability, uniform chemical composition, good processing performance and welding performance, high dimensional accuracy and surface quality. causes of rust when brown spots appear on the surface of stainless steel They were greatly surprised: & rdquo; stainless steel will not rust. Rust is not stainless steel. There may be something wrong with the steel quality. & rdquo; in fact this is a one-sided wrong view of the lack of understanding of stainless steel. Stainless steel will also rust under certain conditionsStop the written technical disclosure, Series & mdash; Martensitic precipitation hardening stainless steel.The back side is not protected by argon on-site technical and safety disclosure to the on-site operators.Safety and health and the flux coated welding wire (self protective flux cored welding wire) + TIG process is adopted. In the s, the backing welding wire has been developed. Recently China has also developed the stainless steel backing welding wire (i.e. flux coated welding wire, such as tgftgftgftgf, etc.) It has been applied to the actual construction and achieved good results. We have successfully applied it in the capacity expansion and reconstruction project of Urumqi Petrochemical.Typical ferritic stainless steels are Crl, Cr and Cr.

During welding, the process of ventilation in advance and gas stop behind shall be adopted, it is not easy to be damaged, so this welding can well ensure that the inner side of the weld is filled with argon and its purity, so as to effectively ensure that the metal on the inner side of the weld is not oxidized and ensure the quality of weld backing welding.Quality recommendation, it can reach a higher welding speed for steel pipes with different materials, outer diameter and wall thickness. Compared with argon arc welding, it is more than ten times its high welding speed. Therefore, stainless steel pipes for common use have a higher consumption rate. Due to the high speed of high frequency welding, it is difficult to remove burrs in welded pipes. At present, which is also one of the reasons.(IV) high level operation of steel plant and social inventory. The contradiction between market supply and demand spread to the circulation field, and the domestic steel inventory continued the growth trend at the end of the previous year. On March it reached a historical high of . million tons, an increase of . million tons over the previous high, including . million tons of construction steel inventory, accounting for % of the total inventory. After that, with the increase of seasonal consumption, the inventory gradually fell back to . million tons on July . The oversupply in the market also pushed up the inventory of steel mills. In mid March, the steel inventory of key enterprises reached a historical record, reaching . million tons, a year-on-year increase of %. In late June, it fell to . million tons, still an increase of % over the beginning. Professional stainless steel plate, stainless steel coil, stainless steel belt, stainless steel pipe and other products have a complete variety and sell well at home and abroad. The equipment has a long service life! Products lead the industry in wire products. Welcome to inquire. An increase of % over the same period in .Since the beginning of last year, foreign countries have frequently carried out & ldquo; Double inverse & rdquo; This has a great impact on China's stainless steel casting industry. Export is a large part of the development of China's stainless steel industry and occupies a huge market share in its industrial development. In the face of economic downturn and slow development,JarucoStainless steel honeycomb tube, the development of China's stainless steel industry should constantly improve product quality, Better develop overseas trade and deal with trade protectionism, combine products with environmental protection, energy resources and cultural environment,Stainless steel pipe, which was produced and used in China at the end of the s, is a new family emerging in the field of pipe materials. It has been widely used in building water supply and direct drinking water pipelines.Pipeline direct drinking water has developed rapidly. With the development of national economy, pipeline direct drinking water has developed rapidly in domestic cities such as Beijing, Shenzhen, Shanghai and Chongqing, and economically developed medium-sized cities have also actively planned to catch up. In direct drinking water, stainless steel pipe system is undoubtedly second to none. At present, domestic high-grade hotels and public places have been equipped or are equipped with direct drinking water pipes.Welding, high frequency preheating plus three torch argon arc welding, high frequency preheating plus plasma argon arc welding. The progress of combined welding is very significant. As for the combined welding of steel pipe with high-frequency preheating, the weld quality is equivalent to the conventional argon arc welding and plasma welding, the welding operation is complex, and the whole welding is easy to complete automation. This combination is easy to connect with the existing high-frequency welding equipment, with low investment cost and good benefit.