If the hot water within ℃ is recommended, the hot water pump must be used, and the external tap water shall be connected for cooling during operation, otherwise the motor will not be burned due to too high medium temperature.　　 It may be that the motor power of the water pump is too large, the working current is too large, resulting in the high temperature of the vacuum pump.lubbock ,　　 the float switch can automatically control the start and stop of the pump according to the required liquid level change,lubbock Used pipeline pump, without the need for special personnel, which is very convenient to use.　　In fact, it can only be opened or closed, and the action time when opening and closing is relatively short.Thiruvananthapuram,　　Through the introduction, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact, it also needs to be used in a correct way when it is used at ordinary times. Only in this way can　　Yes,lubbock Long shaft submerged slurry pump, such mechanical faults will cause the stator winding of the pump to be burnt out.　　The solution to the excessive temperature of the water pump: when selecting the motor, it is necessary to select one that matches its power and speed. In addition, the cooling fan should be installed on the main shaft. It is also possible to appropriately increase the number of fan blades but pay attention to adjusting the vacuum pump

　　In this way, the solvent in the pump is often less when the equipment is used again, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is　　And it shall be used according to the quota specified in the manual.　　 If it is found that the impeller is damaged and the liquid supply is insufficient, it is necessary to replace the new impeller in time for use.market price,　　The submersible slurry pump is a kind of submersible pump which is connected with the motor and works underwater at the same time. In addition, compared with horizontal slurry pump and vertical slurry pump, submersible slurry pump has the great advantage of flexibility and convenience, the blank operation point can be supplemented.

　　Rate.How much is it,　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.　　At this time, the molecular structure of the coating itself has good compactness which can well isolate the air, water and other media from the pump impeller during use, and also reduce the corrosion and rust as much as possiblelubbock ,lubbock Submersible sewage pump,　　After understanding the working principle of the submersible slurry pump, we will also know that those parts are prone to wear during normal use. In this way, we can carry out targeted anti-corrosion and wear-resistant treatment on these parts during optimization, so as to improve the integrity of the equipment and　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged, there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submerged　　 We also need to make choices according to local conditions when we make purchases at ordinary times. For example, the head of the centrifugal pump itself is relatively high, but its water output is not very large when it is used, so it is effective when it is used in many mountainous areas