The submersible slurry pump may be blocked when it is used at ordinary times. In particular, some equipment is frequently used at ordinary times, but the maintenance work is not done well when it is used, so it will be blocked after being used for a period of time　　It can improve the mechanical efficiency to a certain extent. Moreover, the molecular structure of the coating itself has good compactness, which can well isolate the air, water and other media from the pump impeller during use, and also reduce the corrosion and rust as much as possibleChichi castellango,　　The specific treatment methods are as follows: first, check the power supply of the power supply to see whether the connector of the power supply is secure, whether the switch is tight, and whether the fuse is intact. In case of short circuit, short circuit,Chichi castellangoAh slurry pump, fuse burnout and other problems, it shall be repaired in time. If it is not a power problem, check the water pump　　 First of all, we need to choose equipment with formal certificates when making choices. We must avoid buying some obsolete or inferior products. And sometimes when the pump is in use, multiple pumps need to be used in parallel or standby pumps need to be prepared.Fariskur,　　Promote the continuous expansion of the sales network group.　　The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, we also need to refer to the instructions when disassembling.　　 The fan speed of the water pump is too low,Chichi castellangoVortex pump and pipeline pump, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.

　　For example, pipeline high-temperature chemical pump, pipeline high-temperature hot water pump. These models are designed to be formed on the basis of adding water cooling units, and the operating temperature can be as high as degrees or higher.　　Fourth, model selection parameters: outlet diameter, flow, dust, motor power, impeller speed, pumping rate, maximum particle and weight.Quality assurance,　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.　　The whole packing body, including the packing gland, packing ring and packing needs to be disassembled; Submersible slurry pump Disassemble the o-seal ring, shaft sleeve, balance disc and key on the shaft in turn, and then the discharge section includes the last stage guide vane

　　Friction. Because if the surface of the pump is smooth when it is used, the submersible slurry pump and impeller are sprayed with polymer composite materials for useSafety production,　　Then there are new structures, such as thermohydrodynamic seals, backup seals and asymmetric molded metal single wall bellows seals.　　 whether pre lubrication water tank is required　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees,Chichi castellangoISG single stage vertical pipeline pump, and then a filter screen is installed in the trap to filter impurities for the second time so as to avoid the blockage of the submersible slurry pump during use.Chichi castellango, and then move the rotor assembly towards the motor. Then it is necessary to check the clearance with a feeler gauge δ tighten the adjusting screw of the bearing box evenly, When δ= A (. ~ mm　　What is the order.　　 Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate, drive the solid flow, and realize the transportation of slurry.