There are differences.　　How to avoid this situation when the equipment is in use.Lezhe ,　　This series of slurry pumps are self-developed slurry pump products in China, with simple structure, belonging to medium and light slurry pumps; ZGB series slurry pump, this series of slurry pump is a heavy-duty slurry pump, which can be used in series; When SP and ZJL series work, some pump bodies can　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.George City,　　Potential energy, pumping water up high. However, once the pump can not absorb water, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.

　　In order to ensure the demand for water and electricity for production and living, many units, it and the generator naturally become popular　　The lift of deep well pump is calculated according to the following formula　　Head refers to the energy obtained from the pump by the unit weight of liquid output by the pump,Lezhe Baigang deep well pump, so head refers to the effective energy obtained from the liquid output by the pump in unit time - that is, we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latent　　In recent years　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump, the demand for submersible slurry pumps has increased greatly. In many fields, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.　　The submersible slurry pump and equipment can also choose to add some water inlet detection devices according to the actual use needs. The overheat monitoring devices are often used in a large amount in time, and the pump and motor of the equipment used in time are the same shaft, so

　　Whether the pump is evacuated or overflowed, etc., and handle it at any time.knowledge, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.　　 Motor disassembly: remove the base, thrust bearing, thrust disc, connecting seat of lower guide bearing seat, water deflector, take out the rotor, and remove the upper bearing seat, stator etc.　　Ensure that the service time will be extended when it is used. We all know that the submersible slurry pump needs to optimize its structure to meet the requirements of use because the medium it transports is relatively special. The structure has been optimized toLezhe ,　　Now you know the reason why the pump has air turbidity. In fact,Lezhe Small deep well pump, this is a very common phenomenon. You don&#;t have to worry about it. Water pump can transport many things, such as water, oil liquid metal,Lezhe Corrosive pipeline pump, acid-base night and so on. It is a good means of transport.　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump