When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.Acapulco,　　The impeller channel reaches the outer edge.　　 First of all, we need to know that submersible pumps generally operate in water. In fact, one of the media conveyed by sewage pumps mayTougan,　　Fourth model selection parameters: outlet diameter, flow, dust,AcapulcoLong shaft submerged slurry pump, motor power, impeller speed, pumping rate, maximum particle and weight.　　Now you know the reason why the pump has air turbidity. In fact, this is a very common phenomenon. You don&#;t have to worry about it. Water pump can transport many things, such as water, oil, liquid metal, acid-base night and so on. It is a good means of transport.　　Friction. Because if the surface of the pump is smooth when it is used, the equipment will consume less energy when it is used. Generally, let&#;s learn about the packaging and sealing method of the equipment: packing sealing is very common in submersible slurry pumps. This method has good sealing performance, is easy to use, and effectively reduces the wear of the host and anti vibration kinetic energy　　The liquid level of slurry shall be higher than the inlet of pump.　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.Service first,　　 When stopping the operation of the submersible slurry pump close the cock of the vacuum gauge and pressure gauge and the gate valve on the water outlet pipeline, and After that cut off the power supply of the motor. If the temperature of the environment is low, open the square plug at the lower part of the pump body to remove the remaining water to avoid frost cracking. During operation, the maximum temperature of the bearing shall not exceed ℃, and the quantity of calcium base grease used for lubricating oil bearing shall be the same as that of the bearing body　　The type selection design of submersible slurry pump has a great impact on the service life and operation stability of slurry pump. A scientific and reasonable model selection design will affect whether your slurry pump can achieve the best efficient operation.　　 If there is no corresponding water leakage sensor, it is necessary to regularly maintain the submersible slurry pump and replace the seals.

　　 There is also a vibration method to measure the vibration frequency of the pump, and the measurement is relatively simple. However, when using one method, the measurement results may have some errors. When using the submersible slurry pump, there are other vibration sources that will affect the measurement results, so it is actually the mainVariable cost,　　Pump, sewage submersible pump and seawater submersible pump.　　 water　　Moreover, the leaked flammable, explosive and toxic liquid will cause fire,AcapulcoPipeline pump, explosion and poisoning, and the consequences will be unimaginable.Acapulco,AcapulcoSubmersible pump can pump sewage,　　The hardened mud layer collapses after softening, avoiding the phenomenon of burying the pump during use.　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows　　Auxiliary mixing or spraying device shall be equipped for easier operation. When the motor is submerged, there is no need to build complex ground protection and fixed devices, and the management is easier. The mixing impeller directly contacts the deposition surface and controls the concentration through the diving depth, so the concentration control is more free. Equipment directly submerged