High lifting height,BudaElectric barrier free elevator,BudaIndoor small electric elevator, using side mounted oil cylinders,BudaElectric small elevator, stable operation, easy maintenance, and longer service life.Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, and should not open towards the lifting passage.Buda,The installation position of the lower limit switch. The installation position of the lower limit switch should ensure that the contact plate triggers the switch when the rated load of the suspension cage decreases, causing the suspension cage to stop. At this time the contact plate should also be close to the triggering of the lower limit switchWhen the foundation is set on the roof or floor structure, the bearing capacity of its supporting structure should be checked.Ijebu-Igbo,The hydraulic oil forms a certain pressure by the vane pump, and enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve, and balance valve, causing the hydraulic cylinder to move upwards and lift heavy objects. The return oil at the upper end of the hydraulic cylinder returns to the oil tank through the explosion-proof electromagnetic directional valve, and its rated pressure overflow valve is adjusted. The pressure gauge observes the reading value on the pressure gauge. The downward movement of the hydraulic cylinder (i.e. lowering of heavy objects).When the wall bracket adopts non matching standard products, design calculations should be carried out.In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, and a toe board at least mm above the ground.

The landing door should meet the requirements of the specifications and achieve standardization.A lifting platform with specifications ranging in height from meter to meters.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Where is good,There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results, and report any problems found to the user unit.When the horizontal distance between the edge of the cage and the edge of the landing or between the cage and the landing door is greater than mm and there is no effective protection from other structures, the side protection device for the landing entrance should be equipped.

Construction electric elevators outside the lightning protection rangeWelcome calls ,The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.Fully autonomous lifting is widely used in various high-altitude work fields, such as factory maintenance, airport maintenance, street light maintenance, and so on; How to use electric elevators correctly to extend the service life of the equipment and be flexibleSetting requirements: The verticality deviation of the installation of the guide rail frame of the construction electric elevator should comply with the requirements of the user manual and specifications,Setting requirements: Before starting work every day and changing shifts, the driver of the construction electric elevator should inspect the construction electric elevator according to the requirements of the user manual and specifications, record the inspection results and report any problems found to the user unit.The foundation production and acceptance of electric elevators for foundation construction should comply with the user manual and regulatory requirements.Manual pump: When the system malfunctions, the manual pump can be operated to pump high-pressure oil to raise the car to the nearest floor position