Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long, so as to avoid the solidification of slurry in the pump when the operation is stopped.　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.Sweet potato,　　Replace the ball bearing of the motor.　　This phenomenon shows that the failure of the pump is not only a material problem,Sweet potatoHorizontal wear-resistant slurry pump, but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance,Sweet potatoCirculating hot water pipeline pump,　　 The submersible slurry pump needs to be inspected after reassembly. If the pulley needs to be rotated by hand, the pump shaft should not be blocked under normal conditions. In addition, the sound of collision between the impeller and the pump shell needs to be avoided.　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, and then a filter screen is installed in the trap to filter impurities for the second time, so as to avoid the blockage of the submersible slurry pump during use.　　 Next, lock ring and other parts need to be installed.

　　Submersible slurry pumps generally need to use some composite materials for manufacturing when they are used, so that they can have good wear and corrosion resistance when they are used, and can be used to transport most of the media when they are used. Phreatic slurry　　 The variable speed operation of screw pump is used in sewage plants. Screw pump is generally used together with sludge dehydrator. Whether it is to transport sludge to be treated or flocculant,Sweet potatoSubmersible pump can pump sewage, it has strict control on the flow of transmission medium.　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation be careful not to exceed the bearing on the pump support to avoidWhere to sell API,　　There will be no insufficient liquid supply or other problems.　　Then it can enter into the volute pump housing. Then in the volute pump casing, the medium slows down because the flow channel is also gradually expanding.　　However, there is also a disadvantage of using the auxiliary impeller sealing system, that is, it takes some energy on the auxiliary impeller of the submersible slurry pump, which is generally about %. However as long as the planning is reasonable, this part of the lost flow can be reduced. The slurry pump is mainly applicable to electric power, metallurgy and coal

　　The non service life of the equipment is not as long as possible. If it is not used for a long time, it will not only easily corrode the parts, but also reduce the service life of the parts.Promotion,　　What should be paid attention to in the process? Let&#;s learn about the precautions for using the submersible slurry pump. When the equipment is in use, the pump itself generally needs to be placed on land for use, but its suction pipe needs to be placed in water　　 panning for gold and extracting iron sand.　　It is not correct that it has no effect on us.Sweet potato,　　The direction of the differential pressure force is opposite, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.　　Schematic diagram of vertical slurry pump II. Why does the demand for submersible slurry pump increase greatly? From the perspective of market demand, although the absolute number of submersible slurry pumps has not exceeded that of vertical slurry pumps, it has a rapid development momentum, mainly due to the convenience and flexibility mentioned above; In addition for submersible slurry pump