BedgoshUsed electric elevator platformHow to do a good job of cold treatment
2024-04-20 01:53:19The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than m. In special circumstances, when the net height of the building entrance is less than m, it is allowed to lower the height of the lower door opening, but in any case the net height of the lower door opening is not less than m. (Article of GB-)Setting requirements: Drainage measures should be set up for the foundation of construction electric elevators to ensure smooth drainage.Bedgosh,When adding hydraulic oil,Bedgosh5 meter electric spiral elevator, it is also necessary to pay attention to the structure of the oil cylinder. Some oil cylinders are relatively complex internally, and how many lifting operations need to be carried out during filling to fully fill each position of the hydraulic oil. Therefore, when filling, try to add as much as possible, and then test and run the machine empty to see if it reaches the rated position.Spiral electric lifting mechanism: With all the functions of a regular lifting platform, the main feature is that the equipment occupies a small foundation pit and has a large stroke. The equipment has a height of only -mm and a travel distance of up to m. It is particularly suitable for buildings with stages built on two or more floors due to space constraints.Senaki,The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side, and the door bolt must be set on the side next to the construction electric elevator.When the landing door is closed, the full width of the lifting passage opening should be covered.During loading and unloading, the horizontal distance between the edge of the cage door and the edge of the landing station should not exceed mm.
The safety distance between the outer edge of the upper part of the landing door and the moving parts of the electric elevator during normal operation should not be less than .m; If the rated speed is not greater than .m/s, the safety distance can be .m.The occurrence of.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.Inspection environment,Setting requirements: For construction electric elevators that operate in multiple shifts, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.The bearing capacity of the ground under the concrete foundation plate should be greater than .Mpa.Safety performance: Electric elevators not only have the safety device of traditional traction elevators, but also have an overflow valve to prevent excessive system pressure during upward movement
Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.Quality improvement,From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.Precautions during operation: Mechanical operations should be gentle and smooth, and mechanical operations should be avoided, otherwise impact loads will inevitably occur,BedgoshCurved arm electric elevator, causing frequent mechanical failures and greatly shortening the service life. Generated during homeworkThere is no need to set up a computer room above the shaft like an elevator,BedgoshElectric three wheel car lift, and the top floor height can be installed at least . meters.Bedgosh,Operating cost advantage and low failure rate: Due to the use of advanced hydraulic systems and good methods, the operating failure rate can be reduced to a low level.The spacing between wall brackets and the height of guide rails above the high attachment point should comply with the requirements of the user manual.It is reported that a fixed electric elevator has good lifting stability and can only be used for fixed operations