SentesElectric elevator 5 metersWhat does it mean to enter the international market
2024-03-09 00:15:32When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door the door may not meet the above requirements,SentesElectric fork lift table, but safety should be maintained.The distance between the electric hoist and overhead line in Electrical safety construction shall meet the specification requirements otherwise protective measures shall be taken.Sentes,A lifting platform with specifications ranging in height from meter to meters.There is no need to set up a computer room above the shaft like an elevator, and the top floor height can be installed at least . meters.Danli,Stage equipment safety door. To prevent personnel from extending their heads, hands, and feet out of the shaft and objects from falling into the vertical shaft. Its vertical position should be closed, its cabin should be full of doors, and the height of the hoistway (hall door) should not be less than meters; The electric door opening and closing switches should be removed from the vertical and passenger compartment doors. In order to prevent accidents caused by vertical, passenger car doors, and car roof doors not being closed.; Door interlocks should be installed on both the vertical and passenger compartment doors.Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination,SentesOutdoor electric lifting platform, large stroke, stable operation, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.
Civil engineering advantages: The pit depth of the guide rail type lifting platform is generally around -mm, and the top layer is not affected. It can be customized according to the location and environment.Before installing the construction electric elevator, the foundation should be inspected and approved before installation.Setting requirements: The wall bracket should use the manufacturer's matching standard products.ranking,SentesFixed electric hydraulic elevator,Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Setting requirements: The spacing of wall brackets along the vertical direction should comply with the provisions of the user manual.The counterweight guide rail should meet the specification requirements.
The entrance of each landing platform must be equipped with a landing door, and the door bolt must be set on the side next to the construction electric elevator.Sales Department,When the distance between the outer edge of the construction electric elevator and the edge line of the external overhead power line cannot meet the requirements in the table above, effective protective measures should be taken.Lower limit switch: In normal working state, before the suspension cage touches the buffer, the lower limit switch first acts.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Sentes,Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Every theater is a public place with a large number of people, and safety considerations should be taken into account in stage design. According to relevant national regulations, in order to prevent accidents caused by the crushing of electric elevators or improper control by drivers. Electric elevators should be equipped with the following necessary safety devices to ensure that the car of the electric elevator stops rising or falling in a timely manner.Low power consumption: When the hydraulic guide rail lifting platform descends, it is driven by the pressure generated by its own weight, greatly saving energy and reducing consumption.