Now there are many solid wood floor renovation boards on the market. The renovation boards are processed with solid wood floors as raw materials. They are recycled at low prices and sold at high prices, with considerable profits.How can we avoid buying refurbished boards?The first is cleaning to remove oil stains or dust;The second is leveling. The convex part shall be shoveled and polished. The concave part can be made into paste with glue and cement at the weight ratio of :, leveled with a spatula, and then leveled with sandpaper after drying.After the ground is flat, clean and dry, it can be glued and paved.Gluing is the last process before paving, and the tool shall be a toothed rubber scraper.During gluing, glue shall be applied on the ground according to the size of the floor paint cloth, and one piece shall be paved in this order.A width of cm shall be reserved at the joint of the floor paint cloth. No glue shall be applied first, so that the joint can be treated finally.When the glue coated on the ground feels sticky by hand, it can be paved. When pasting, pay attention to aligning the sidelines, and use a long handle floor brush to blow out and compact.The joints are generally spliced by overlapping cutting, and the overlapping width is about cm.Align the long steel ruler with the center of the overlap, cut with a cutter along the ruler, then remove the cut edge strips (note that there should be two edge strips, don&#;t forget to take out the lower one), apply an appropriate amount of glue to the joint with a paint brush and then close and compact the joint with a pressing roller.The residual glue extruded at the joint shall be wiped clean to avoid affecting the appearance.Then apply a thin layer of joint liquid along the joint.Finally, check whether there are bubbles and whether they are flat.If there are bubbles, use a syringe to insert and suck out the air, and then compact it.Finally, use washing powder to remove the residual glue marks on the lacquer cloth. If they cannot be removed, they can be wiped with alcohol.In this way, the grade of interior decoration is also rising, and the decoration materials are increasingly developing towards the fixed decoration direction of elegance, high profile, long service life and good effect.As for the ground, the service life of paint, carpet or ordinary floor leather and floor brick is not as long as that of ground lacquer cloth.LasLomas,Then select one or more floor waxes, which can be adjusted to the same tone as the floor.Heat the strip solid recovery wax with an electric soldering iron and fill it on the scratches on the floor. No scratches can be seen. Ultra light and ultra-thin, SPC floor has a thickness of about mm-mm and light weight,LasLomasWhat brand is laminate flooring good, which is less than % of ordinary ground materials. It has incomparable advantages in stair bearing and space saving in high-rise buildings. At the same time, it has special advantages in the reconstruction of old buildings.Aracaju,Look at the substrate, break the floor, and look at the substrate inside. There are no impurities in the good substrate, and the color is relatively pure. You can see a lot of impurities in the poor substrate with the naked eye.Most domestic floors use fast-growing forests, and wood has been used since - years. However, imported floors, especially FSC certified plates, have strict restrictions on wood types, so wood substrates are better. Advantages.In fact, it is very simple to prevent wood floor cracking. Usually, do a good job in floor maintenance and humidification of wood floor in areas with low average moisture content, or raise flowers and fish at home, most of the strengthened solid wood composite floors are up to standard commodities within the scope of standardized formaldehyde emission.According to relevant requirements, the formaldehyde emission of commodities in the room shall be class E, i.e. ≤ mg/l.Look at the substrate, break the floor and look at the substrate inside. There are no impurities in the good substrate and the color is relatively pure. A large number of impurities can be seen with the naked eye in the poor floor substrate.Most domestic floors use fast-growing forests, and wood has been used since to years. However, imported floors, especially FSC certified plates, they still prefer pure solid wood flooring according to the results before the general evaluation.If there are cracks inside the wooden floor, it must be replaced.As a result, the internal cracks will lead to the depression of the wood floor, which has a great impact on the normal use.Bidding,SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, blocks, plates or coils can be selected.Floor lacquer cloth, also known as floor leather (not PVC plastic floor), is a kind of paving material. It belongs to rubber plastic products. It is one of the indispensable floor materials for the decoration of power distribution room, substation and communication room. The thickness is -mm. Other thicknesses can be made according to the needs of users. The wear-resistant layer is generally less than or equal to .mm.The choice of lacquer cloth products shall be selected according to the suitability of the site.For example, the size of the product is determined according to the space of the house and the size of the place of use.At the same time,LasLomasFloor leather square meter price, pay attention to the different places of use, and the selected patterns should also be different.For example, in places that need to be kept clean, you can&#;t choose products with convex effect;In solemn places, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm, mm and mm;The total thickness (referring to the base material, intermediate layer and surface wear-resistant layer) is divided into mm and mm;The length of each roll of floor leather is m and m.Other specifications and dimensions can be determined by the supplier and the buyer through negotiation.Because of the requirements of production, each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced), so the length of the small section of a roll of floor paint cloth with sections shall be indicated, and the length of the roll of floor paint cloth shall be increased by at least cm (i.e. not less than two complete patterns).Generally, there can only be one section for high-quality products, and the number of sections of each volume of first-class products and qualified products shall not exceed ;The length of each section of first-class products shall not be less than m, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, it should be visually inspected obliquely under the scattered sunlight or fluorescent lamp with the illuminance of ( ± LX and LM away from the tested sample.First, fractures and delaminations on the surface of the floor leather. If so, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is deemed as qualified. Go back to the third step to observe whether there are missing patterns on the surface of the floor leather and whether there are defects of the transparent wear-resistant film on the surface. If there is no, it is the first-class product and the first-class product. If there is slight missing or lack of film, it is the qualified product, otherwise it is the unqualified product.Finally, whether there are color differences in different parts, whether the superior products are uneven and if there are the above two defects, and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally the first-class products are those with but not obvious, based on the above judgment, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name, product mark, grade, batch number, quality and length shall be marked at the obvious place of each package.In addition to the above three items that can be directly judged by the senses, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life.The surface texture of solid wood floor is clear and natural, and there is no obvious color difference on both sides.Medium and low grade solid wood floors indicate that cracks may occur.If the crack is not a problem between textures, there will be some hidden dangers if the crack passes through the texture.Finally heat conduction is fast.

Super wear-resistant. The wear-resistant layer on the surface of SPC floor is a transparent wear-resistant layer processed by high technology, and its wear-resistant revolution can reach about revolutions.According to the thickness of wear-resistant layer, the service life of SPC floor is more than - years.SPC floor is a long-life floor, especially suitable for public places with large flow of people and high degree of wear.Honest service,Some customers want to take a lighter to light the SPC floor to see if it can burn. If it burns, it is not fire safety, and if it doesn&#;t burn, it is flame retardant.In fact the national regulations on the flame retardant grade of PVC latch floor meet the B Standard, and the flame retardant raw materials are listed as class a fire safety according to the national standard, such as marble, wall tiles, etc.The technology of Class B flame retardant grade includes mm diameter cotton wool, sprinkled with ethanol, and placed on the PVC latch floor for natural ignition. After the cotton wool is burned, accurately measure the diameter of the burned PVC latch floor impression. If it is less than mm, it is Class B flame retardant grade.Instead of watching it burn.The construction of SPC floor installation works is very fast. There is no need for mixed mortar. The ground with good standard can be paved immediately and can be applied after hours. The ground is slightly weak. Only self leveling cement is needed to ensure that the height difference of the ground is within mm.Foot feelLasLomas, Solid wood flooring.For laminate flooring the main standard of floor environmental protection is formaldehyde emission.In terms of the limitation of formaldehyde emission standards, the environmental protection of the flooring industry has experienced three technological revolutions: E, E and FCF.At an earlier stage,LasLomasWhich is better, wooden floor or floor tile, the formaldehyde emission standard of wood-based panel is E level (formaldehyde emission ≤ mg / g), and its formaldehyde emission limit is very loose. Even for products meeting this standard, the formaldehyde content may exceed more than three times that of E level wood-based panel, seriously endangering human health so it must not be used for home decoration.Therefore, the flooring industry implemented the E level environmental protection standard, that is, the formaldehyde emission is ≤ ‡ / L. although it basically does not pose a threat to the human body, there are still a lot of free formaldehyde left in the floor.The flooring industry has started the second environmental protection revolution and launched E environmental protection standard, which has reduced the formaldehyde emission of the floor to . ‡ / L.The best way to identify whether the floor is environmentally friendly is to pry the floor from the lock with a screwdriver and hammer, so that the floor substrate is exposed in a large area, and then smell it with your nose. A good floor should have a wood smell, but a bad one has a strong pungent smell!Advantages: it is warm for many days and cool in summer. Of course, the lines are comfortable on the feet and resist germs.