The Tao part also consumes part of it.　　 Prepare tools and materials: a set of metric box / open-end wrench, bearing puller (commonly known as triangle puller), magnetic dial indicator, outside micrometer, caliper, feeler gauge square ruler, copper bar, screwdriver with handle, hammer,cornerQuotation slurry pump, V-shaped irons of the same specification, oil basin, cotton yarn, etc.corner,　　The quality of the substitutes produced is not up to the standard, and the price of imported spare parts is expensive; Moreover, the flow passage parts of the centrifugal dehydrator are more sensitive to sand particles. Therefore, sand particles in the conveying medium shall be minimized.　　Only in this way can its service life be extended to a large extent.Beni Khiar,　　The motor is scrapped. Moreover, because the length of the long shaft is generally fixed, the installation and use of the pump is troublesome, and the application occasions are subject to many restrictions.　　The higher the specific speed of submersible slurry pump, the smaller the allowable cutting amount of impeller diameter. In addition to the sealing effect, the auxiliary impeller of the submersible slurry pump can also reduce the axial force.　　Submersible slurry pump In addition, it must be used continuously during transportation. If there is an interval in the middle, it must be avoided that the interval is relatively long so as to avoid the solidification of slurry in the pump when the operation is stopped.

　　In addition,cornerWQ submersible pump parameters, the sundries inside the pump body and impeller shall be cleaned. Then calibrate the pump shaft and motor shaft of the slurry pump to make them on the same horizontal line.　　QW (WQ) non clogging submersible sewage pump QW (WQ) non clogging submersible sewage pump IV. the submersible sewage pump uses V power supply, which should be three-phase power supply. If the submersible pump has only two-phase power supply, it will not start. In this case, a professional electrician should be asked to use a clamp on ammeter or a submersible pump control　　Through the introduction, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact, it also needs to be used in a correct way when it is used at ordinary times. Only in this way canTrustworthy,　　 When the slurry pump fails to absorb water during operation,cornerSubmersible slurry pump, it may also be because the bottom valve is not opened. At this time it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　Body. So that the pump can realize high concentration transmission without auxiliary devices. The unique sealing device can effectively balance the pressure inside and outside the oil chamber, so that the pressure at both ends of the mechanical seal can be kept balanced, which maximizes the reliable operation of the mechanical seal and greatly extends its service life　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller

　　Rate.Excellent service,　　Function of shaft seal of submersible slurry pump: the main of shaft seal is to prevent high-pressure liquid from leaking out of the pump and prevent air from entering the pump.　　Try to select the pump with appropriate lift.　　If there is a standby pump, it is better to use two pumps in turn. If the pump is stuck, the pump can only be repaired. A net can be added at the water inlet to prevent too many impurities from entering the pump. In this way, the probability of pump sticking will be much smaller!corner,　　Do a good job of fixing to avoid the motor falling into the water and directly scrapping.　　.　　 It is also possible that the fan blades of the pump are few and the air volume is insufficient