The application of pumps involves all aspects of work and production, and the types of pumps are also diverse. Some of the same pump have several names, and some of the names are very similar,CorollaDrilling fluid slurry pump, which makes it difficult to distinguish. Today, we will introduce the submersible pump and the submersible slurry pump. Is there any difference between the two　　 Next, it is necessary to check the water seal. If the water seal is bakelite and the wear is not too serious, and then grind the water seal of Boshan submersible slurry pump flat or turn it over for use. However, if the thrust rubber water seal is used, whenCorolla,　　The impeller channel reaches the outer edge.　　In order to make the equipment perform better when it is used, but this also needs to be based on its working principle. It can not be adapted at will when it is optimized.Wave,　　When the slurry pump is working, the pump needs to be placed on land, the suction pipe in water,CorollaCentrifugal slurry pump, and the pump needs to be started. Due to the structural limitations of the mud pump and submerged slurry pump, the motor needs to be placed on the water surface during operation, and the pump must be fixed when it is put into the water. Otherwise, the motor will fall into the water　　 After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties,CorollaCirculating hot water pipeline pump, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improved

　　Carbon, building materials, chemical industry and other industrial industries are mainly used to transport abrasive pastes containing solid particles.　　The maintenance personnel shall regularly check the tightness of the diving cable whether the steel wire rope or guide chain is worn, and whether there is garbage; Regularly check whether the three-phase phase resistance of the water pump is balanced and whether the insulation resistance to ground is less than m Ω; Regularly check whether the electrical protection device is reliable and　　The direction of the differential pressure force is opposite whether it is fixed properly,　　After a certain value, water will also vaporize, which is called the vaporization pressure of water at this temperature.　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.　　 It may be that the motor power of the water pump is too large, the working current is too large, and the heat generation is too large, resulting in the high temperature of the vacuum pump.

　　The use of water pumps for agricultural drainage and irrigation can improve the ability of agriculture to resist natural disasters, increase production and ensure income, and provide material conditions for agricultural mechanization and water conservancy.Safety and health,　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, and there is a very important component water seal in the pump, which can separate the pump body from the motor, so it mainly plays a role in use　　The discharge side of the pump must be equipped with a valve (ball valve or stop valve, etc.) and a check valve. The valve is used to regulate the operating point of the pump. The check valve can prevent the pump from reversing when the liquid flows back (the long shaft deep well pumps produced by our company are equipped with anti reversing check devices) and prevent the pump from being hit by water hammer　　Submersible pump is a common water lifting equipment for deep wells. During operation, the whole machine intrudes into the water to extract water from the underground to the surface. It is commonly used for domestic water, mine rescue, industrial cooling, seawater lifting ship load adjustment, landscape fountains, etc. Submersible pump is generally divided into clean water submersibleCorolla,　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water, otherwise the mechanical seal will be burned.　　For example, in the market, for example, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, it is necessary to check whether the bottom valve is open and make corresponding adjustment.