In the middle and late ten days, although there were good news such as the rise of futures and the increase of production restriction policy in Wu an region, due to the high inventory level, traders had no desire to increase prices, most of them had shipped goods, the market inventory in Handan reached a high level after the festival. The sluggish demand performance for a long time led to the oversupply of the market, and the continuous rise of inventory led to the empty market mentality.Because of the characteristics of copper itself, it is very easy to rust and corrode in places with high ambient humihumidity. If we often use it, the problem will be smaller, but if it is placed for a long time, the copper will be damaged. Many people do not know how to treat the copper surface? Now let the staff answer for you.Benguela,Try to avoid using radiator copper pipes in hot water circulation pipelines to reduce the possibility of corrosion. If copper pipes are used as circulation pipelines, pipeline maintenance space should be reserved.The price of tube billets was adjusted and lowered mainly due to the production restriction of environmental protection and the weak demand for temperature and weather. Recently, causing a weak shock. According to the communication with local traders in Cangzhou, various good news last week led to the shipment of thermal expansion pipes in Cangzhou in the past two weeks, which is better in the off-season, and the shipment of some specifications has improved. However, the trading atmosphere in the small and medium-sized pipe market is still cold, and the demand is slowing down gradually. To sum up, it is expected that the market price of Cangzhou seamless pipe will be stable and weak in the near future.Yangon,Disadvantages of copper pipe As far as copper pipe is concerned, high production cost and high price are its biggest disadvantages. Compared with other pipe fittings,Benguela310s stainless steel pipe, the cost of copper pipe is much higher, and the connection at the copper pipe interface requires high construction technology level.Extrusion method: This production method is to cast copper ingots after smelting, and extrude copper tubes by large extruder after secondary heating.Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, the welding flux must have a degree of corrosivity, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.

Hygiene and health: various modifiers, additives, additives and other chemical components of plastic pipes in copper pipes.In addition, it is very strong, not easy to be corroded, and can adapt to various environments. It can be used normally at low and high temperatures, so copper pipes need to be selected many times in other places. The color change on the outer surface of the copper tube is difficult to control due to environmental factors. To prevent moisture absorption on the surface and core of the annealed brass tube, a constant temperature and humidity packaging room can be built. Packaging in the packaging room can avoid the color change on the outer surface of the copper tube. However, it is not easy to control the situation that occurs in the processing process. The cost of ensuring constant temperature and humidity in the whole workshop is too high. The following measures are taken to control the process materials: In the season of high temperature and humidity, the amount of oil coating on the surface of copper tubes can be increased to form an oil film on the surface of copper tubes, which can isolate water vapor and corrosive gases, and prevent the corrosion of the surface of copper tubes; The humidity in the air at night is high, and the outer surface of the copper pipe is prone to corrosion and discoloration at night. Closing the doors and windows of the workshop at night can make the situation worse; After the coil surface is cleaned in the rewinding process, the coating amount of passivation agent on the copper tube surface is increased. After blanking in the rewinding process, plastic bags shall be added to the whole support material to further reduce the contact between the copper pipe and the air and prevent the surface of the copper pipe.The room temperature tensile strength of the annealed red copper sheet is ~ kgf/mm, the elongation is ~%, and the Brinell hardness (HB) is ~Where is good,When stacking, it shall be stacked reasonably and placed first.The main force of iron ore futures closed at in The closing price of the day today was the same as that of the previous trading day, including * * * * ,BenguelaAlloy plate, * * * , settlement price , trading volume , and position volume . The intraday tradg volume decreased by compared with the previous trading day, and the position volume decreased by compared with the previous trading day. After six consecutive days of downward adjustment, there was a rebound at the bottom of the session today, but it was corrected again later, and the closing was flat.Among the three production methods of copper tube, the copper tube can be produced. Thisthod is also the most common method to produce copper materials. It has not only been used for a long time, but also has a mature technology, which is to produce copper tubes through oxidation reaction. This production method is the main production method of copper tubes in China.

Red copper inventory in key areas has risen continuously, but the total pressure is not big. From the current overall inventory situation of the main distribution centers Wu an Jiangyin and Lecong, and the pressure on the market is relatively small. In Wu an market the inventory level remains relatively moderate, according to the data, as of May , the total inventory of medium and thick plates in Wu an was close to tons, increasing by tons on a weekly basis. In late April, it reached tons lower in the year, down tons from the high level after the Spring Festival, and rose for three consecutive weeks. In terms of the ovquantity, it should be said to maintain a relatively moderate level.management,Disadvantages: low output, high production cost and high price. Extrusion copper tube process is a stable and excellent copper tube production method at home and abroad at present. Only the copper tubes produced by this process are more suitable for the field of heating and ventilation, which is the development direction of copper tube industry in the future.In order to solve these problems, silicon containing welding wires are commonly used in welding, because silicon will form a layer of dense silicon film on the surface of the molten pool, which will hinder the evaporation of zinc and prevent the invasion of hydrogen.In terms of steel billets: at :, some steel billets in Changli were reduced by , and the current carbon square billets were delivered with tax of yuan. After the th National Congress of the Communist of China, the market had doubts about the uncertainty of environmental production restriction and was still waiting for a clearer direction. Therefore, it can be seen that at this stage, there was no unilateral market for either futures or cash, and there was no definite pattern of ups and downs. According to the monitoring data of Lange Iron and Steel s cloud business platform, as of the time of publication, Tianjin Youwelded Line: the steel mill reported: Rongcheng # yuan/ton, B yuan/ton; Jiujiang # - # to Tianjin yuan/ton; The arrival price of Xinji Aosen # is yuan/ton and that of B steel is yuan/ton; Jiyuan # yuan/ton, B steel yuan/ton; Fulen # yuan/ton; Weigang # yuan/ton, B steel yuan/ton.Benguela,Red copper inventory may end the trend of continuous decline. With the increase of production restriction of steel enterprises and the pressure of demand, the continuous decline of iron ore port inventory may end. In addition, the available days of imported iron ore of steel mills are days, which is one day lower than that before the National Day, and is on the high side of history. The steel mill said that at present, the iron ore inventory basically meets the production requirements. Considering the future production reduction and restriction, the steel mill is not willing to replenish the inventory.Later Mexican scientists also found that copper has a . Recently, British researchers found that copper has a strong bactericidal effect. It is believed that in the near future, copper will make great contributions to improving human health. Copper plate T is named after its purple color. It is not necessarily pure copper, sometimes it also involves a few deoxidizing elements or other elements to improve raw materials and s,BenguelaRed copper tube, T T, T, oxygen free copper plate (TU, TU and high-purity, vacuum oxygen free copper), deoxidized copper plate (TUP, TUMn), and special copper plate (arsenic copper, tellurium copper, silver copper) with a few alloy elements added. The conductivity and thermal conductivity of copper plate are second only to silver, and are widely used to manufacture conductive and thermal conductive devices. The red copper belt has outstanding corrosion resistance in the atmosphere, sea water, some non oxidizing acids, alkalis, salt solutions and a variety of organic acids (aic acid, citric acid), and is used in the chemical industry. In addition, the red copper plate has outstanding weldability and can be made into various semi products and products through cold and thermoplastic processing. In the s the output value of copper plate exceeded that of other copper alloys.In Jiangyin market, another distribution center, the overall inventory of the current circulation link is about tons slightly lower than the normal level. At the beginning of this week, the price gap between Jiangyin prices and those in the north has also been able to correspond to the slightly lower circulation inventory. However, from the perspective of the policy port of the steel plant, the overall production situation of Nangang, Hengrun, Dada, and the amount of resources in the later period remains stable. The overall inventory of Lecong market remains at about to tons, which is a medium normal level, and the recent spot price of Lecong market has a large gap with that of the north.