the submersible slag pump is often used to transport pulp containing solid particles, so the wear resistance of the pipeline should also be considered.　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.Kingston,　　Microcomputer controller LW light: cause: the light is on and the machine stops, the water level is low, the water level returns to normal, and the machine starts automatically.　　 First, screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeveMacara,　　In addition, the sundries inside the pump body and impeller shall be cleaned. Then calibrate the pump shaft and motor shaft of the slurry pump to make them on the same horizontal line.　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　Pressure. Therefore, a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.

　　In fact, the impeller clearance of submersible slurry pump is not adjustable for all types of pump, the clearance needs to be adjusted regularly to keep the clearance within the range suitable for normal operation.　　Tighten the terminal blocks.　　Do not exceed the rated current.The cheapest,　　With water, you can start working.　　Moreover, the leaked flammable,KingstonSingle stage slurry pump, explosive and toxic liquid will cause fire, explosion and poisoning and the consequences will be unimaginable.　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.

　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.Quality risk, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumping　　 There are several reasons for the severe vibration of the pump body: the phenomenon of unbalanced rotation of the electric rotor.　　Therefore, when the pump temperature is too high you don&#;t need to panic. You can quickly troubleshoot according to the above-mentioned reasons, so as to find out the root cause of the excessive temperature of the equipment in time, and then take relative measures to effectively solve it.Kingston,　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage in order to meet the needs of market development,KingstonScrew deep well pump, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generators　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.　　If there are sundries blocked, the pump will not be filled with water. When this happens again, technicians need to properly adjust the liquid level in the pump sump to a proper height, it needs to be replaced in time,