Horizontal lead screw mechanical electricityThe use of a lifting platform as a tool for storing performance blankets, soft scenery, etc. In some theaters, there is a soft scenery storage lifting platform located at an appropriate location on the stage for the storage of blankets, soft scenery,OldenburgTeveso, etc.Oldenburg,The working principle of the aluminum alloy lifting platform is that hydraulic oil is composed of a vane pump to form a certain pressure, which enters the lower end of the hydraulic cylinder through an oil filter, explosion-proof electromagnetic directional valve, throttle valve, hydraulic control one-way valve, and balance valveDuring normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed mm. Otherwise, measures should be taken to make it meet the requirements, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed mm.odessa ,The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than m. In special circumstances, when the net height of the building entrance is less than m, it is allowed to lower the height of the lower door opening, but in any case, the net height of the lower door opening is not less than m. (Article of GB-)The quality of the standard section should comply with the product manual and specification requirements.During loading and unloading,The L distance depends on the selected wall mount model.Low level doors should be equipped with interlocking devices that can verify their closed and locked positions. The action of this interlocking device should be at the entrance of the cage. Simple use should not interfere with the operation of the interlocking device. The attached wall bracket should use matching standard products. When the wall bracket cannot meet the requirements of the construction site, it should be designed separately. The design of the wall bracket should meet the requirements of component stiffness strength, stability, etc., and the production should meet the design requirements.Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).

Construction electric elevators should be equipped with cable guide frames and comply with regulatory requirements.market price,The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, m/s.When applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding mm; After the test,OldenburgPiacenza, it worked normally.Oldenburg,In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, a half height middle crossbar,OldenburgGdansk Ancient City, and a toe board at least mm above the ground.High lifting height using side mounted oil cylinders, noise free, easy maintenance, and longer service life.Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.