BisegliUpatarPositioning method
2024-02-21 00:54:22Safety grounding device. In order to protect against electrical equipment. The metal casing of electrical equipment and the metal structure of electric elevators should be equipped with a safety grounding device. The grounding wire should operate multiple wires, and the neutral wire should not be arbitrarily held as a safety grounding wire. Its grounding resistance should not exceed ohms; The power supply of the electric elevator can be cut off.To meet the needs of stage craftsmanship and layout; Product; In the music and dance theater stage arranged in a zigzag pattern, auxiliary lifting platforms are often arranged in front, back, left, and right of the main stage lifting platform. The side and rear auxiliary lifting platforms are used for the smooth opening of the side platform and rear vehicle turntable while the front auxiliary lifting platform is used to place the rear vehicle turntable near the platform entrance. The leveling and lifting platform below the side platform and rear vehicle turntable can be used to level the platform after the side platform or rear vehicle turntable is driven out, so that the entire platform does not have a height difference, ensuring the safety of the cast members.Bisegli,BisegliXinji,And prevent it from starting normally. There should be no device that allows users to cancel warning signals.Setting requirements: The quality of the standard section should meet the requirements of the product manual. Before installing the construction electric elevator, all components should be inspected, and standard sections and other components with severe wear and deformation should be replaced.Gargzdai,Double layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.Protective measures should comply with regulatory requirements.Drivers of construction electric elevators should hold special construction operations and are not allowed to operate without a certificate.
Acceptance: Concrete strength grade C, strength testing report.Before each shift of work, the safety devices of the construction electric elevator should be inspected to ensure sensitivity and reliability.The pump body adopts an integrated pump station, all equipped with imported high-quality pump stations, which can also be selected according to customer requirements to meet customer ideal requirements.Welcome calls ,When a rigid mm square or circular flat surface is applied with a normal force of N to either side of the door,BisegliKalish, the door may not meet the above requirements, but safety should be maintained.High lifting height, using side mounted oil cylinders, stable operation,BisegliXita, noise free, easy maintenance, and longer service life.Many theaters use a lifting platform as a vertical transportation tool for goods. The rear of the main stage or the end of the side stage in many theaters are equipped with a set container transportation lifting platform, which is used to vertically transport items from the ground to a designated location or even the stage plane. The lifting platform of the music pool is often used for transporting movable seats, etc.
Before operating the construction electric elevator, routine inspections should be carried out according to regulations and inspection records should be filled out.Product range,Construction electric elevators outside the lightning protection rangeThe impact load can cause early wear, as well as generate impact pressure in the hydraulic system, which in turn can damage hydraulic components, oil seals, and high-pressure oilEmergency manual valve: In case of power failure it can cause the car to descend to the nearest floor position and open the doorBisegli,Setting requirements: For construction electric elevators that operate in multiple shifts, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.The verticality of the guide rail frame should meet the requirements of the specifications.Secondly, for the replacement of hydraulic oil on the lifting platform, it is recommended to replace it every three months. If the frequency of use is not high it can be replaced once a year. The hydraulic oil must be clean, and after changing the hydraulic oil, it must be automatically lifted and lowered to times to ensure that the air in the oil cylinder is completely discharged, maintain sufficient space, and ensure that the lifting platform can be lifted to the rated lifting height.