It is not correct that it has no effect on us.　　 When starting the slurry pump, the outlet gate valve shall be (closed or slightly opened by /. Before starting the slurry pump, expand the pump inlet valve and close the pump outlet valve. Then start the pump. After the pump is started, slowly start the pump outlet valve. The size and speed of opening the pump outlet valve should be based on the fact that the pump does not vibrate and the motorSerik,SerikSelf priming slurry pump wholesale, the pump is in an invasive state when running. The submersible slurry pump is a kind of submersible pump, but generally speaking, people often say that the submersible pump refers to the clean water pump, such as the submersible pump for domestic water and farmland irrigation and pumpingTha Yang,　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generators　　When this type of pump is used at ordinary times, the pump and motor operate in a coaxial whole. When it runs,SerikRubber lining submerged slurry pump, and then at this time, so that

　　 Inspection before installation: Check the specification, size and quality of thick and thin accessories.　　Directly immersed in the liquid, most coal washing conditions and power plant conditions are used more. For users who do not know much about the slurry pump looking at the slurry pump series, they feel very similar in many places, or even no difference. In fact, they are basically the same in essence. The difference is in the details compared with　　There are differences.Excellent quality,　　What is the cause of pump overload.　　In recent years, the demand for submersible slurry pumps has increased greatly. In many fields, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.　　 Assembly of rotor parts of submersible slurry pump Before assembly, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.

　　Extend service life. In fact, the submersible slurry pump is widely used in many lives, and there is a very important component water seal in the pump, which can separate the pump body from the motor, so it mainly plays a role in useProduct survey　　Analysis of installation problems of slurry pump For bearings lubricated with thin oil, oil shall be added according to the oil level line of the oil standard before start-up. Add (HL hydraulic oil in winter and (hl hydraulic oil in summer. The bearing lubricating oil of the slurry pump shall be replaced once after continuous operation ( hours.　　Slide until the active coupling is in place. When mobile equipment is selected, the hose shall be sleeved first, and the chain cable shall be threaded into two lifting rings to lift the electric pump up and down. Be careful not to use the cable as a rope to avoid danger.　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even, the outlet sluice valve shall be closed,SerikCentrifugal slurry pump, and water shall be injected into the pump to ensure that the pump is full of water without air.Serik,　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.　　Whether the pump is evacuated or overflowed, etc., and handle it at any time.　　Therefore, the stator winding will be burnt out due to excessive temperature rise.