Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller　　 There is also a vibration method to measure the vibration frequency of the pump, and the measurement is relatively simple. However, when using one method the measurement results may have some errors. When using the submersible slurry pump, so it is actually the mainKomapa,　　It is worth noting that the QW mobile type is generally used without a fixed position so it is usually used temporarily without an electric control cabinet, and a special person is required to control the shutdown of the water pump.　　 It may be that the motor power of the water pump is too large, the working current is too large, and the heat generation is too large, resulting in the high temperature of the vacuum pump.Maynooth,　　If the submersible slurry pump cannot be installed and operated, the blank operation point can be supplemented.　　Submersible pump is a common water lifting equipment for deep wells. During operation, the whole machine intrudes into the water to extract water from the underground to the surface. It is commonly used for domestic water, mine rescue,KomapaSubmersible slurry pump, industrial cooling, farmland irrigation, seawater lifting, ship load adjustment, landscape fountains, etc. Submersible pump is generally divided into clean water submersible　　Do not exceed the rated current.

　　The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall be　　Fire pump control cabinet generally has two control modes: one is fire hydrant control, and the other is spray pump control. The working principle of the spray pump control cabinet is that the pressure controller is designed with a normally open contact. When the pressure relay acts due to the pressure difference, the control circuit moves the main circuit　　The input quantity is related to many factors such as the rotating speed of the submersible slurry pump, the bearing standard, the continuous working time,KomapaLong shaft submerged slurry pump,KomapaWQ submersible pump parameters, the surrounding environment and the working temperature. Therefore, it is necessary to gradually accumulate the experience and add smooth oil in a reasonable and timely manner.Quality department,　　The water pump can be used to transport and pressurize clean water without impurities, such as apartment, residence, villa water supply, factory water supply, water supply system, drinking water system and water treatment. In short, there are many uses.　　Stability and reliability of seals between pump bodies.　　Therefore, when the pump temperature is too high, you don&#;t need to panic. You can quickly troubleshoot according to the above-mentioned reasons, so as to find out the root cause of the excessive temperature of the equipment in time, and then take relative measures to effectively solve it.

　　About %), and motor power p=i × U indicates that high power and current will increase.Encyclopedic knowledge,　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows　　The pipeline support is unstable and shakes.　　What stands out is the sealing of the container. The seal is easy to install and maintain, but the price is quite expensive.Komapa,　　 First remove the pump from the engine.　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.　　Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.