DelamondvilleLong shaft submerged slurry pump,

　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.　　Be sure to choose a pump that is more suitable for use.Delamondville, it can be directly installed in the sewage tank without building a special pump room to install pumps and machines, which can save a lot of land and infrastructure costs.　　Line direction pay attention to the direction of rotation. Then loosen the original compression nut of the bearing box of the slurry pump of the submersible pump,DelamondvilleIrrigation deep well pump, tighten the adjusting screw of the bearing box evenly, and then move the rotor assembly towards the motor. Then it is necessary to check the clearance with a feeler gauge δ, When δ= A (. ~ mmViljoenskroon,　　 Before starting the submersible slurry pump, the rotor of the rotating pump shall be smooth and even the outlet sluice valve shall be closed, and water shall be injected into the pump to ensure that the pump is full of water without air.　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, but also reminds the pump designers and producers that in addition to good working conditions, the pump should also have good corrosion resistance, high reliability and long service life. The pump shall be designed in addition to the conventional design method of fluid mechanics

　　What is the cause of pump overload.　　However, with the increase of pump operation time, it is bound to be accompanied by the decrease of pump efficiency and the wear of flow passage components. The most serious parameter affecting the pump characteristic curve is the wear of the pump impeller. After the wear of the impeller, it is equivalent to the downward movement of the pump H-Q curve, which reduces the flow and head　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.Latest consultation,　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, about % are used in concentrators in the mining industry. Due to the poor working conditions of primary ore dressing, the service life of slurry pump in this section is generally low. Of course, different minerals, abrasion　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation, be careful not to exceed the bearing on the pump support to avoid

　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.Work courses,　　It is not correct that it has no effect on us.　　Fire pump control cabinet generally has two control modes: one is fire hydrant control, and the other is spray pump control. The working principle of the spray pump control cabinet is that the pressure controller is designed with a normally open contact. When the pressure relay acts due to the pressure difference,DelamondvilleCirculating hot water pipeline pump, the control circuit moves the main circuit　　The installation of submersible slurry pump is a step that needs to be concerned. Since we all care about it it is mainly because the installation will directly affect the use effect. The installation work should be seamless. Some key operating points can be seen when installing the slurry pump.Delamondville,　　Be sure to choose a pump that is more suitable for use.　　Reasonable.　　 One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When