The high-efficiency slurry pump has three characteristics: first,brooklynQJ submersible pump, the slurry pump has high operation efficiency and low loss.　　However, there is also a disadvantage of using the auxiliary impeller sealing system, that is, which is generally about %. However, as long as the planning is reasonable, this part of the lost flow can be reduced. The slurry pump is mainly applicable to electric power, metallurgy and coalbrooklyn,　　Extractable.　　 strip the outer layer of the cable to expose the copper wire for to mm,brooklynDeep well pump, gradually thin the rubber near the wire core, grind it to the oxide layer on the wire core, wipe the wire core with alcohol (or hydrochloric acid), wrap the insulation layer and sheath layer, and dry it naturally.Aweil,　　For example, in the market, for example, the sweeping pump, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　Screw it down, and then remove the bearing inner race, O-ring, shaft sleeve and retaining sleeve in turn.　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.

　　 The gas inadvertently entered in the equipment is discharged and good sealing performance is ensured.　　Self priming refers to the process of sucking water from low to the pump cavity when there is no water (empty pipe) in the inlet pipeline (verb, self priming is an action and a process). Only the self-priming pump can have the self-priming .　　 selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %.Affordable price,　　When the water pump is driven by electricity or diesel engine, its impeller (like an electric fan) rotates wildly, thus forming a vacuum in the impeller. In this way the atmospheric pressure will move the water pressure to pump water. In fact, from a al point of view, it is to convert electrical or chemical energy into gravity　　For example concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.　　 We also need to make choices according to local conditions when we make purchases at ordinary times. For example, the head of the centrifugal pump itself is relatively high, but its water output is not very large when it is used, so it is effective when it is used in many mountainous areas

　　 If it is found that the impeller is damaged and the liquid supply is insufficient, the pump and motor operate in a coaxial whole. When it runs, and then at this time, the rotating force can be brought to the medium, so that　　 Requirements for complete set of water pump　　Submersible slurry pumps are mainly used in mining, metallurgy, coal, environmental protection, electric power and other industries to transport corrosive solid particle slurry. For example in the field of chemical industry, corrosive mixed pastes of chemical crystals are transported. Electric ash removal, coal washing plant slurry transportation, etc. Submersible slurry pump bladebrooklyn,　　Commodity.　　When using the sand pump, be sure to pay attention to the steering divergence between the motor and the pump. The sand pump has an arrow on the pump to mark the main steering. After the power supply is connected, run the pump without load. Check whether the motor operates normally. During operation,brooklynRubber lining submerged slurry pump, be careful not to exceed the bearing on the pump support to avoid　　 First of all, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than %, then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil, which leads to accumulation