High price performance price ratio: due to different structures, the regulations on wood are not too high. Raw materials can be used flexibly, and the price is much lower than that of solid wood flooring. Do not scrape or scratch the floor surface with sharp tools.Farola,The reinforced composite floor with good base material will give off a fresh wooden smell. The composite floor with weak base material will produce a strong pungent smell. The author randomly picked up two wooden floors and put them in front of his nose. The pungent smell from one wooden floor made the author frown immediately. Customers may wish to smell the floor closely when purchasing, and do not buy inferior floors.Don&#;t pour the floor wax directly on the wooden floor.Otherwise, there will be traces and traces.Carefully apply according to the wood grain direction of the wood floor. Do not apply or the thickness is uneven.Too little application will cause uneven thickness, and too much application will lead to poor film formation.Keeping thin and uniform is the key to waxing.Do not dilute the floor wax with water.Solid wax must be ground after polishing.Bembereke,In this category, it should be noted that the release of formaldehyde must take a whole process of time. The formaldehyde content tested at this stage does not represent the long-term formaldehyde content.In addition, pay attention to whether there are sawdust and stratification on the cutting surface of the plate and whether there are sawdust and stratification on the cutting surface of the solid wood floor. Ultra light and ultra-thin, SPC floor has a thickness of about mm-mm and light weight, which is less than % of ordinary ground materials. It has incomparable advantages in stair bearing and space saving in high-rise buildings. At the same time, it has special advantages in the reconstruction of old buildings.

Formaldehyde damage.The key to the wear resistance of laminate floor lies in the content of aluminum trioxide on the surface and a certain wear-resistant revolution matches a certain content of aluminum trioxide.The wear-resistant revolutions of family wood flooring are generally above revolutions, which can be purchased according to the requirements.Fifth, smell with your nose is not protected by the environment.Job description,The surface is treated with special technology, without air holes and water impermeability. It is no problem to shop in the areas where toilets and kitchens communicate with water.No, it will not be like the ordinary wooden floor. Once it bubbles, it will deform and bubble, or it will become moldy due to high humidity. Moisture proof, no deformation in case of water, and can be used in kitchen, toilet, basement, etc.Service is not only related to the guarantee of product quality, but also the performance of corporate image.Some deformation, warping and cracking of floor products appear soon after installation, whether the service is professional or not also affects the performance of products. Dust-free installation is popular in floor installation. Dust pollution in home decoration can not be underestimated. For example,FarolaToilet floor, in floor installation engineering, sawdust and dust will inevitably appear and float in the air and its harm is also long-term and serious.People who move into new houses often suffer from a strange disease of 'new house syndrome'. For example, when they get up every morning, they feel suffocated, nausea, and even dizzy;Easy to catch a cold;I often feel uncomfortable in my throat, poor breathing, dizziness and fatigue after a long time.This is because the respiratory tract is infected, and the biggest inducement is the invasion of dust suspended in the air for a long time.In order to avoid dust pollution, it is best to choose dust-free installation.

Then look at the qualityWhere to sell API,Precautions for solid wood floor installation : solid wood floor cannot be used immediately after disassembly and packaging.Looking at the bar code formal reinforced composite floor, the back of the floor will be printed with not only the brand trademark, but also the model,FarolaHow thick is the floor leather, wear revolutions, environmental protection grade and other information of the floor, so that consumers can see it at a glance.When assembling the solid wood floor do not be too loose or too tight.The assembly relaxation shall be reasonably arranged according to the temperature of the indoor environment. The assembly relaxation will produce a large gap with the shrinkage of the floor.The assembly is too tight and the floor is arched when it expands.Farola, Common floor types:SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, plates or coils can be selected.Floor lacquer cloth, also known as floor leather (not PVC plastic floor), is a kind of paving material. It belongs to rubber plastic products. It is one of the indispensable floor materials for the decoration of power distribution room, substation and communication room. The thickness is -mm. Other thicknesses can be made according to the needs of users. The wear-resistant layer is generally less than or equal to .mm.The choice of lacquer cloth products shall be selected according to the suitability of the site.For example, the size of the product is determined according to the space of the house and the size of the place of use.At the same time, pay attention to the different places of use, and the selected patterns should also be different.For example, in places that need to be kept clean, you can&#;t choose products with convex effect;In solemn places, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm, mm and mm;The total thickness (referring to the base material, intermediate layer and surface wear-resistant layer) is divided into mm and mm;The length of each roll of floor leather is m and m.Other specifications and dimensions can be determined by the supplier and the buyer through negotiation.Because of the requirements of production, each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced) so the length of the small section of a roll of floor paint cloth with sections shall be indicated, and the length of the roll of floor paint cloth shall be increased by at least cm (i.e. not less than two complete patterns).Generally, there can only be one section for high-quality products and the number of sections of each volume of first-class products and qualified products shall not exceed ;The length of each section of first-class products shall not be less than m, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, it should be visually inspected obliquely under the scattered sunlight or fluorescent lamp with the illuminance of ( ± LX and LM away from the tested sample.First,FarolaTips for cleaning laminate flooring, observe whether there are cracks, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is deemed as qualified. Go back to the third step to observe whether there are missing patterns on the surface of the floor leather and whether there are defects of the transparent wear-resistant film on the surface. If there is no, it is the first-class product and the first-class product. If there is slight missing or lack of film, it is the qualified product, otherwise it is the unqualified product.Finally, carefully check whether there is deviation during multi-color overprint on the surface, whether there are color differences in different parts, whether the superior products are uneven, and if there are the above two defects, the first-class products are those with but not obvious, and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally, based on the above judgment, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name, product mark, grade, batch number, quality and length shall be marked at the obvious place of each package.In addition to the above three items that can be directly judged by the senses, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life. What does the real wood floor look like?