One frequency converter with one slurry pump is adopted for installation. The specific transformation method is as follows: close the return valve, adopt the water level closed-loop control mode, install the liquid level sensor on the inner wall of the tank by the manufacturer of the slurry pump, and use the PID adjustment of the frequency converter. When　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.Big hagui,　　The sub bearing and cylindrical roller bearing can bear the maximum axial and radial loads of the pump. The bearing is lubricated with grease. The two ends of the bearing body are provided with sealing end caps, labyrinth sleeves and labyrinth rings, which can effectively prevent dirt such as mineral slurry from entering the bearing, ensure the safe operation of the bearing and have a high service life.　　When the submersible slurry pump is used at ordinary times, cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?the Philippines,　　The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining.　　Submersible slurry pump is a kind of pump that can adapt to various working conditions and can treat various sewage from environmental protection industry. Let&#;s take a look at the maintenance measures for the accessories of the submersible slurry pump.　　 the submersible slag pump is often used to transport pulp containing solid particles, so the wear resistance of the pipeline should also be considered.

　　After meters, the sealing of the equipment can not bear the water pressure at this depth.　　 water　　 The slurry pump mainly aims at conveying flow, so the flow meter (meter) shall be installed in the operation monitoring system as far as possible to monitor whether the flow meets the requirements at any time; In the pipeline system slag flushing system and pressure filtration dehydration system equipped with hydrocyclone, certainagent,Big haguiVertical slurry pump,　　In fact,Big haguiPipeline pump, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　Troubleshooting: first increase the water pressure then inject water into the pump body, and then start the pump. At the same time, check whether the check valve is tight and whether the pipes and joints leak. If air leakage is found, apply lubricating oil or mixed paint on the joint after disassembly, and tighten the screws.　　During normal operation, the temperature of the motor is very high some even as high as ℃. In this case, it is easy to burn the motor and replace it with a new one. In fact, one motor burns out at this time. Don&#;t worry about replacing it. You must find out the cause of the motor&#;s heating, or

　　 If the power cord is not well contacted, it will also lead to the burning of the motor.supply,　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating,Big haguiWQ submersible pump parameters, check valve, bottom valve, vent valve, pressure gauge, etc. are required　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.Big hagui,　When using the submersible slurry pump, the equipment may be burned out. The main reason for this phenomenon is improper operation. How should we prevent the burning out?　　When in use, it can drive the impeller to rotate so as to drive it to flow.　　Some corrosive pastes containing crystals can also be transported. In the application range of slurry pump, the service life of slurry pump in this section is generally low. Of course, different minerals, abrasion