Jaruco Vertical centrifugal slurry pumpProduct quality shall be strictly controlled
2023-03-12 12:13:36The fixing method of the impeller is changed from screw thread to key clamp to prevent the impeller from falling off and causing damage! determination of model: for water pump or pump with physical and chemical medium similar to water, it is necessary to go to the relevant product catalog or sample, The system shall be equipped with a fire control cabinet. First, screw down the bolts on the side bearing pressure cap,Jaruco ZD slurry pump, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleeveHollola, The effective power is also called output power which is expressed by PE. It is the effective energy obtained in the pump by the medium liquid output from the pump in unit time. The vertical sand pump is generally a submersible slurry pump. Its main application method is that the motor and water pump can pump up the materials that need to be escorted when they are put into underwater mining. Stability and reliability of seals between pump bodies.
It is not correct that it has no effect on us. Structural features of horizontal slurry pump: The ah, HH and L-type slurry pumps at the pump head are of double pump shell structure, that is, the pump body and cover are equipped with replaceable wear-resistant metal lining, sheath and guard plate are made of high chromium wear-resistant metal. The pump body and cover are made of grey cast iron according to the working pressure If the impeller of the pump is damaged after a long time of use, it will also lead to insufficient liquid supply for the pump.Superior quality, The purpose is to inject liquid higher than . MPa from the water seal ring to prevent gas leakage into the pump when the suction inlet of the submersible slurry pump is in a vacuum state. When the water pressure in the pump is higher than . MPa, the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakage Therefore, when the pump temperature is too high, you dont need to panic. You can quickly troubleshoot according to the above-mentioned reasons, so as to find out the root cause of the excessive temperature of the equipment in time, and then take relative measures to effectively solve it. After each use of the equipment, high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.
First remove the pump from the engine.quality, After that, before starting again,Jaruco Circulating hot water pipeline pump, check whether the impeller rolling is normal and whether the bearing assembly compression bolts are tightened, at least in recent years, the situation of power shortage will continue, and Chinas economic growth trend will maintain a high speed. Therefore,Jaruco QJ submersible pump, the contradiction between power supply and demand is still prominent in recent years, which is undoubtedly an opportunity for it and the generator industry. In water pumps and generators, especiallyJaruco selection of pump head: generally, the pump head shall be determined by enlarging the margin of % - %. Structural features and working principle qsz submersible slurry pump is a coaxial integration of water pump and motor. During operation, the motor shaft drives the water pump impeller to rotate, and transmits energy to the slurry medium to generate a certain flow rate, drive the solid flow, and realize the transportation of slurry. The first stage impeller of the pump is disassembled; It is also necessary to screw down the connecting nut between the water absorption section and the bearing body and the bolt on the bearing pressure connection, so that it is convenient for us to disassemble the bearing parts; When the shaft is pulled out from the suction section, the fixing nut on the shaft shall be