There are differences.　　 First remove the pump from the engine.victoria,victoriaPipeline pump,　　Try to select the pump with appropriate lift.　　It is an auxiliary means of on-site monitoring. During the operation of the submersible slurry pump,victoriaDouble suction slurry pump, the condition of its overflow parts is very important to the overall operation. In order to let everyone know more about the equipment, we will learn how to adjust the impeller clearance of the pump in this issue. I hope it will help you.Bama,　　It is also necessary to clean the ventilation duct to avoid blockage.　　Ordinary vertical motor can be used without waterproof, while the motor shaft and pump shaft of submersible slurry pump are coaxial, so the motor must be waterproof and sealed, and the motor and pump can be immersed in liquid at the same time; The vertical slurry pump is an early product, and the submersible slurry pump is a newly developed product according to the market demand　　During adjustment, firstly loosen the support cover, then compress the nut, tighten the compression nut of the bearing seat evenly to make the assembly move towards the pump head. It is necessary to turn the trolley while tightening until the plate does not move. Rotate according to the pump operation

　　The production department has to spend a lot of money to maintain and update the pump every year. The pumps made of cast iron, bronze, rubber lining, stainless steel, titanium alloy and other materials used in China&#;s mining, chemical and water conservancy projects on the Yellow River are prone to wear, short service life and many faults　　 Working conditions　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.Welcome calls ,　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　Second, the power used is not matched, so the motor temperature will be too high after long-term overload operation; In addition frequent startup during use will also lead to fever, so I　　The of descending axial force can be used for slurry transportation in power plants hydraulic and other professions; The mechanical seal is tight and reliable, and the leakage probability does not exceed drops /min, which is mostly used to transport flammable, explosive, toxic, high pressure and low temperature.

　　It is also necessary to clean the ventilation duct to avoid blockage.Where to sell API,　　During the process, the equipment must be regularly maintained and overhauled to avoid blockage. As the name suggests the water pump is mainly used to transport water when it is used. The effect of normal pumps is often better when it is used,victoriaWQ submersible pump parameters, but in fact, low motor temperature rise, no pollution to the environment.　　 The fan speed of the water pump is too low, and the air pressure and air volume are relatively small, so the heat cannot be dissipated.victoria,　　 If the head of the submersible slurry pump is too low or the head is higher than the practical condition, the flow will be large and the current will rise. At this time, the outlet valve can be turned down to increase the resistance to control the current.　　Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.　　If the pump outputs more medium liquid, it will certainly do more work. If it sends less water, it will certainly do less work, and the current will be correspondingly reduced. Pump power (kw) = head (m) × Flow (m/s) × The gravity of the fluid (kg/m for water) divided by (power conversion factor) divided by the efficiency of the pump (about