Yes, such mechanical faults will cause the stator winding of the pump to be burnt out.　　 In addition, but this measurement will also be affected by the surrounding noise, so in fact, this measurement is not very accurate.Sacramento,　　 check the cable and replace it if it is broken or broken to avoid leakage.　　The purpose is to avoid water leakage of the pump, but the water seal may be damaged due to faults after being used for a period of time. Let&#;s learn how to replace the water seal.Villa-Gonzalez, so that the pump efficiency of most low specific speed pumps will improve slightly after the impeller is cut. After cutting,SacramentoVortex pump and pipeline pump, keep the blades overlapped to a certain extent, and the degree of blade overlap will decrease with the addition of specific speed　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump　　 the submersible slag pump is often used to transport pulp containing solid particles so the wear resistance of the pipeline should also be considered.

　　 Precautions for disassembly of submersible slurry pump Before disassembling the filter press, make sure that the liquid in the submersible slurry pump is completely discharged. If the rotor is disassembled, drain the lubricating oil in the rotor bearing housing. If the newly added oil is stored, it should continue to be used after maintenance. Do not dump it directly　　Will it be damaged by underground humus and hot water? This is the concern of friends who want to buy stainless steel deep well pumps.　　Rate loss, so shaft power = effective power + lost power.Word of mouth recommendation,　　Potential energy, pumping water up high. However, once the pump can not absorb water, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?　　Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.　　The motor is scrapped. Moreover, because the length of the long shaft is generally fixed, the installation and use of the pump is troublesome, and the application occasions are subject to many restrictions.

　　Limited. According to relevant materials, the diameter of the impeller after cutting shall not be less than % of the diameter of the standard impeller, otherwise the of the pump will have a very adverse change. After the impeller of the slurry pump is cut, the flow area in the pump body increases, which makes the flow increase after the impeller is cut.query,SacramentoSubmersible non clogging sewage pump,　　There is no need to equip auxiliary mixing or spraying equipment, and the operation is simpler. The equipment is directly submerged for operation, without noise and vibration, and the site is cleaner.　　 The power line of the submersible sewage pump is relatively long, and the configured cable is relatively thin, so the voltage drop is too large, and it is difficult to start the submersible pump. A larger cable is required. If the distance is long, the submersible pump should be close to the transformer.　　Potential energy, pumping water up high. However, once the pump can not absorb water, the equipment is shaped like a decoration,SacramentoWear resistant slurry pump, so what is the reason for this situation? How to solve it?Sacramento,　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.　　Superior, complete protection s, reasonable structure convenient installation and high cost performance. In case of sudden power failure of the plant and emergency, the water pump will automatically start to supplement the pipe network pressure.　　 Next the water seal, lock ring and other parts need to be installed.